粗大第二相及时效析出相对Al-Mg-Si合金 关键字: Al-Mg-Si合金;第二相;析出相;断裂应变[gap=1417]Key words: Al-Mg-Si alloy; constituent; precipitate; fracture strain
基于126个网页-相关网页
equivalent fracture strain 等效断裂应变
coating fracture strain 涂层断裂应变
local fracture strain 局部断裂应变
fracture strain track 断裂应变迹线
fracture strain limit 断裂应变极限
Fracture strain energy 断裂应变能
Critical fracture strain 临界断裂应变
rock creep fracture strain 岩石蠕变破坏应变
fracture strain energy density 断裂时的应变能密度
Compressed fracture strength increases from 467MPa to 580MPa, and fracture strain increases from 5.2% to 8.7% with increasing the Fe content from 0 to 7 at.
Fe含量从0 at.%增至7 at.%时,压缩断裂强度由467MPa增至580MPa,断裂应变由5.2%增至8.7%。
参考来源 - 含铁和钴Ni·2,447,543篇论文数据,部分数据来源于NoteExpress
The test results shows that AL-liner fracture strain is only 25 % of material ultimate strain.
试验结果表明,铝内衬的极限断裂应变仅为材料极限延伸率的25%。
It is shown that the elastic modulus increases with volume fraction of ceramic particles, though the fracture strain decreases.
研究结果表明,复合材料拉伸弹性模量随增强体含量增加而升高,断裂延伸率下降。
The former two types are brittle ones, and the fracture strain of pyrolytic carbon matrix is the controlling factor of the strength.
前两种为脆性断裂方式,热解炭基体的断裂应变是这类材料强度的控制因素。
应用推荐