Bolt Failure Strength 螺栓失效强度测量
post-failure strength 破坏后强度
Fracture Failure Strength 断裂破坏强度
failure strength criterion 强度破坏准则
peak failure strength 贯通破坏强度
final failure strength 最终失效强度
static failure strength 静态失效强度
fracture failure strength model 断裂破坏强度模型
Strength Failure 强度破坏
The relation curve between the failure strength and the pore density was simulated, which agrees well with the experiential results.
模拟得到了气孔率与失效强度的关系曲线,与试验值基本吻合。
参考来源 - 含孔隙陶瓷基复合材料基体的力学性能和失效问题研究The elastic modulus and failure strength of the lattice elements are randomly determined by corresponding discrete sequences produced by statistical distribution to represent the initial heterogeneity of material properties.
格子单元的弹性模量和破坏强度由按照统计分布生成的相应离散序列随机地确定,以模拟材料性质的初始非均匀分布。
参考来源 - 非均匀材料有效力学性能和破坏过程的数值模拟·2,447,543篇论文数据，部分数据来源于NoteExpress
The maximUm difference of failure strength among various principal stress direction is up to 30%.
不同主应力方向的破坏强度最大差别可达30%。
At last, the failure strength riles of matrix, particle and interface were obtained respectively.
最后分别提出基体、颗粒和界面的失效强度准则。
The mode of fracture changed from ductile to fragile for the BMG composites, but the compressive failure strength increased.
复合材料的断裂由韧性断裂转变为脆性断裂，但压缩断裂强度随着ZrO2含量的增加而得到提高。
应用推荐