The maximum extrusion force and therising value of temperature during extrusion deformation increased with the decrease of extrusion temperature.
最大挤压力和挤压温升随挤压温度的降低而增大。
参考来源 - 7075z铝合金高温塑性变形行为研究·2,447,543篇论文数据，部分数据来源于NoteExpress
The pressure oscillation can be suppressed by either raising extrusion temperature or adopting blending modification.
升高挤出温度和采用共混改性都可抑制压力振荡现象。
The influences of screw configuration, screw speed, extrusion temperature and water contents on extruded starch foams were studied.
研究了螺杆组合、螺杆转速、挤出温度以及含水量对淀粉挤出发泡的影响。
Therefore, lower extrusion temperature and higher screw revolution speed will leads to low foamed HIPS products with good performance.
综上，我们得出：选择较低的挤出温度及较高的螺杆转速有利于得到性能较好的低发泡制品。
应用推荐