按国际近代结构极限状态设计原则,建筑结构设计必须满 足两种极限状态:第一种为 承载能力极限状态 ( Ultimate Limit States ),即结构不因荷载产生破坏失稳的极限状态,该原则已经 得到足够的重视并在设计中严格执行;第二种为正常使用极限 状态(Servicea...
基于362个网页-相关网页
... 使用极限状态 serviceability limit states 最大极限状态 ultimate limit states 安全寿命 safe life ...
基于14个网页-相关网页
At last, In this paper advanced analysis method for steel structure is proved thatcan be used design in ultimate limit states and serviceability limit states by threeengineering examples.
最后,本文将通过三个工程算例来说明钢结构高等分析能进行考虑极限承载力状态和正常使用极限状态的钢结构设计。
参考来源 - 钢框架支撑结构的高等分析及应用研究·2,447,543篇论文数据,部分数据来源于NoteExpress
Presently, most limit-state design codes use reliability principles for designing for ultimate limit states.
目前,大多数极限状态设计规范,运用可靠度原理来对极端极限状态进行设计。
But it is well known that the principle of superimposed stresses is not correct under ultimate limit states of plastic stage.
但众所周知,在塑性阶段的极限承载力状态下应力叠加原理是不成立的。
The general formats for combinations of actions for the ultimate and serviceability limit states are given in en 1990, Section 6.
最终和正常使用极限状态下组合作用的一般格式见en 1990第6部分。
应用推荐