网络释义英英释义
...2.1） 总线速度最大33MHz 总线模式只目标模式下工作 共享内存32 KB页 I/O端口无 电话接口 中继类型环路启动（Loop start）； 环路电流范围20~120mA 阻抗额定值位600欧姆 振铃检测最小15Vrm，13~68.0Hz（由参数设定） 回声损耗可由软件参数设定 串话耦合...
基于24个网页-相关网页
Loop Start Trunk 环路中继
Loop start signaling 回路起动讯号
loop start line 回路起始线
loop start ls 环路启动
Open-loop start 开环起动
Loop-start Trunk 回路启动干线
Start Loop 循环开始 ; 起动回路
start-up loop 启动回路
Loop start
- abstract: Loop start is a telecommunications supervisory signal provided by a telephone or private branch exchange (PBX) equipment in response to the establishment of a closed local loop, commonly referred to as the off-hook state. When idle, or on-hook, the loop potential is held a nominal 48V DC, provided by the telephone exchange or a foreign exchange station (FXS) interface.
以上来源于: WordNet
双语例句原声例句权威例句
-
Next, start the inner loop to read the cells, as in Listing 9.
接下来，开始内部循环以读取单元格，如 清单 9 所示。
-
启动构建循环。
-
Finally, you can start the CruiseControl build loop.
最后，您可以启动CruiseControl构建循环。
-
So we'll loop back to this in just a moment, but start by going back earlier in history.
我们稍后会回来继续讨论,先让我们回到早些时候
-
We start with j pointing here, and we can see what this loop's going to do, right? j is just going to move up.
我们让j指向这里，我们能看到这个，循环要做什么？,对吧，j要开始移动了。
-
If I'm iterating from I on the outside, I on the inside, I'm going to start changing the value and I might very well induce an infinite loop but J is okay.
如果我在外面从I开始迭代，或从里面开始迭代，我将开始改变它的值,我可能引起一个无限循环，但是用J是可以的。
应用推荐