At first, we optimize the control time point and zone number on the MFA-Filling time curve, then we optimize the injection flow rate.
首先在MFA-Fill time曲线上确定出分段控制点(时间)和控制段数，然后再优化出各控制点处的注射流率。
参考来源 - 基于遗传算法的注塑模注射速度优化·2,447,543篇论文数据，部分数据来源于NoteExpress
More injection flow rate, slim branch injection pipe and long pipeline resulted in more resistance at the branch injection pipe.
由于注水量较高、注水支线管径较细、管线较长等原因，导致注水支线阻力偏大；
Conclusion Multi-slice spiral ct can provide quantitative analysis to renal blood perfusion, but injection flow rate influence the perfusion parameters.
结论多层螺旋CT可对肾脏组织血流灌注进行定量分析，但注射流率影响灌注数值。
The total heat loss per unit time decreases gradually as the injection pressure, injection flow rate and injection time increase, but the decrease extent reduces gradually.
随着注入压力、注入流量以及注入时长的增加单位时间的总热损逐渐减小，但是降低幅度变缓。
应用推荐