In static test, T-shaped and L-shaped specimens were respectively divided into four groups according to concrete strength grades, sectional height to thickness ratio, reinforcement ratio and ratio of axial compressive force to axial compressive ultimate capacity of section.
在拟静力试验中对T形和L形短肢剪力墙分别进行了四组试验，通过对试验结果的分析，揭示了混凝土等级、截面配筋率、轴压比和墙肢截面高厚比等因素对短肢剪力墙承载力和变形的影响。
参考来源 - 短肢剪力墙基本性能计算机仿真分析·2,447,543篇论文数据，部分数据来源于NoteExpress
The influence of web plate height to thickness ratio, hole ratio and the width of a single web plate on the buckling capacity of LHFB was analyzed.
分析了腹板高厚比、孔洞率以及单块腹板宽度对LHFB屈曲承载力的影响。
The fundamental problems of ZA27 alloy squeeze casting with high ratio of height to thickness were studied in this paper.
本文主要研究了大高径比ZA27合金铸件挤压铸造过程的若干基本问题。
When the relative gap height (the ratio of flap height to gap width) is in the range of 0 8-2 0, the mean pressure will reduced 30% if the flap height is smaller than the thickness of boundary layer.
底部相对间隙在0 8～ 2 0之间时，扰流片高度小于边界层厚度时的壁面平均压力比扰流片高度大于边界层厚度时小30 %左右。
应用推荐