... Minimum Electrode wear 最小电极损耗 Electrode wear rate 电极消耗率 Electrode Wear Compensation 电极损耗补偿 ...
基于4个网页-相关网页
Based on the systemic experiment design, the effect of electrical parameters on material removal rate and electrode wear rate were studied. The mathematical model and the significance order of the facters were obtained.
在系统试验设计基础上,研究不同电极材料和不同工件材料加工时,电参数对材料去除率和电极损耗率的影响规律,建立工艺指标与电参数之间的经验回归模型,确定各因素影响显著程度,优化工艺条件。
参考来源 - 多曲率油路高效电火花成型加工基础工艺研究·2,447,543篇论文数据，部分数据来源于NoteExpress
The results showed that electrode wear rate was higher at beginning welds than later welds; pitting building at electrode surface accelerated electrode wear and invalidation.
结果表明初始焊接阶段电极磨损速率较大，点蚀加剧了电极磨损与失效。
In the process of EDM, dielectric medium has remarkable influence on material removal rate, surface quality of the workpiece and relative electrode wear ratio.
电火花加工中，放电介质对工件的材料去除率、表面质量以及电极相对损耗率有重要影响。
EDM in gas can make less electrode wear, but its high short circuit ratio will lead to unstable process and thus low material removal rate.
气中电火花加工时电极相对损耗很小，但由于短路率过高导致加工不稳定、材料去除率不高，还会产生烧焦气味。
应用推荐