) for TiC based ceramic die material were obtained. An analysis model for the drawing force during wire-drawing processes is presented.
建立了TiC基陶瓷拉丝模在拉拔加工中的受力分析模型，得到TiC基陶瓷拉丝模在拉拔加工中承受的拉拔力。
参考来源 - 碳化钛基陶瓷拉丝模的研究开发及其相关基础理论研究The instance of drawing force can provide foundation and validation for theoretical study.
拉深力的实例为其更科学的理论研究提供了分析依据和验证。
参考来源 - 拉深工艺的试验研究及有限元模拟·2,447,543篇论文数据，部分数据来源于NoteExpress
And reduction affects drawing temperature little and its increasing lowers drawing force.
变形程度对拉伸温度影响小，变形程度的增大使拉伸力下降。
So the solution can be used to calculation of drawing force during draw-out by idle rolls.
因而，该解析解可在工程上计算圆管辊拔拔制力时推广应用。
The thinning drawing force is calculated through deforming work method and slip-line method irrespectively, and the results are compared in this paper.
本文用变形功法和滑移线法分别求解变薄拉深力，并将两种方法的计算结果进行了比较。
应用推荐