... ultimate design capacity 最终建设规模 ultimate pullout capacity 极限抗拔力 ; 极限拔出力 ; 房屋地政 ultimate working capacity 极限工作量 ...
基于92个网页-相关网页
The Expression of the connection about the ultimate pullout capacity(P) and the Tolerance parameters (β) is: P=-45373β~2-3891.7β+6175.1。
极限抗拔力P与配合参数β之间的关系为式P=-45373β~2-3891.7β+6175.1。
参考来源 - 竹集成材椭圆形榫接合力学特性研究·2,447,543篇论文数据，部分数据来源于NoteExpress
锚杆随着锚固长度的增加，极限抗拔力并不是线性增加的，而是增加得越来越不明显。
With the increase of the anchorage length of the anchor rod, the ultimate pull - out resistance of the anchor rod does not increase linearly, but is less and less obvious by gradual increase.
直接拧入式螺杆的极限抗拔力随着拆装次数的增多而下降，但是，当拆装次数为8-9时，极限抗拔力仍然可达到尼龙预埋螺母的水平。
It declines with the increase of times of direct assembling bolt knocked-down. But it can still reach that of nylon inbuilt nut after knocked-down 8 to 9 times.
最后通过试验土钉抗拔力反算土体与锚固体的极限粘结强度，并与规范推荐值进行了比较。
Finally, the limit cohesion strength between the soil and the nail was obtained by in-situ test, and the results were also compared with those regulated by the technical specification.
应用推荐