... 搭接 lap joint, lapping, overlap joint 搭接长度 splicing length 打底 bedding, priming ...
基于134个网页-相关网页
Lap length is a major parameter for continues purlin design. This dissertation advance a new lap length.
连续檩条的搭接长度也是设计中的一个重要的参数,本程序在分析的基础上提出了合理的搭接长度。
参考来源 - 冷弯薄壁连续檩条CAD系统的研究与开发Bending stress status and destruction mechanism of stitching joint 3-D braided composites were also analyzed. There are two kinds of bending destruction modes and which are also influenced by lap length and stitching density.
不同的搭接长度和缝合密度对缝合连接三维编织复合材料试件的弯曲破坏模式有着很大的影响。
参考来源 - 缝合连接三维编织复合材料弯曲性能研究·2,447,543篇论文数据，部分数据来源于NoteExpress
因此，请用户按接头的搭接长度，确定硫化机的台数。
Therefore, the user presses the length of lap joints to determine the number of curing machine units.
改善尾架与车架的搭接长度，将连接焊缝改为断续焊缝，从而有效地提高了车架的强度。
Also, improve the overlapped length of the tail frame and the frame and change the welding seam into intermittent seam, therefore the frame strength can be effectively increased.
扁钢与扁钢焊接应采用搭接焊，搭接长度至少为扁钢宽度的2.5倍，且至少3边焊接。
The overlapped length should be at least 2.5 times of the width of the flat steel, and at least 3 edges need to be welded.
应用推荐