分析了后减震器帽的成形工艺，介绍了成形该零件的拉深模、翻边模以及旋压模具结构。
The forming technology of rear shock absorber cap is analyzed, and its drawing die, flanging die and spinning die structure are also introduced.
改进了的旧的骨架翻边整形模，采用自动哈夫成形，解决了零件出模困难的问题。
The flanging-sizing die structure of the exo-skeletal was improved, using auto-half block, solved the difficult problem of part out off die.
介绍了双向弯曲(翻边)成形模的结构及工作过程，指出了模具设计、制造时应注意的事项。
The structure and working principle of a bi_directional bending die were introduced. And the points for attention in design and manufacture of the die were listed.
应用推荐