... single flanged lap joint 单法兰搭接 single lap joint 单搭接接头 single lap tile 平搭瓦 ...
基于10个网页-相关网页
This paper optimizes aluminum adhesive process, such as surface treatment, thickness of glue and the ratio of adhesion, by theory analyses and single lap joint mechanical test. The experiment result shows the joints behavior steady made by this adhesive process.
本文通过理论分析与单搭接接头力学试验的方法，优化了铝合金材料的粘接工艺，如表面处理方法、胶层厚度及胶粘剂与固化剂的配比等，试验结果表明应用该工艺制备的粘接接头性能稳定。
参考来源 - 车用铝合金粘接接头在整车撞击中力学行为的简化与仿真This paper optimizes aluminum adhesive process, such as surface treatment, thickness of glue and the ratio of adhesion, by theory analyses and single lap joint mechanical test. The experiment result shows the joints behavior steady made by this adhesive process.
本文通过理论分析与单搭接接头力学试验的方法，优化了铝合金材料的粘接工艺，如表面处理方法、胶层厚度及胶粘剂与固化剂的配比等，试验结果表明应用该工艺制备的粘接接头性能稳定。
参考来源 - 车用铝合金粘接接头在整车撞击中力学行为的简化与仿真·2,447,543篇论文数据，部分数据来源于NoteExpress
研究了间隙长度和间隙位置对不同单搭接接头强度的影响。
The influence of length and position of recessing on the strength of adhesively bonded joints with different single-lap length was presented.
利用有限元方法研究了金属镶嵌对单搭接接头应力分布的影响。
The finite element method (FEM) is applied to investigate the effect of metal inlay in single lap joint on the stress distribution.
研究单搭接接头胶缝中预留间隙对接头拉剪强度和应力分布的影响。
The effect of the recessing on the strength and stress distribution of adhesively bonded single-lap joints is discussed.
应用推荐