This paper is about how to design a mould for an electrical switch box.
本文是针对一个电器开关盒的模具设计。
Mainly by the main control box, the electrical control box, show boxes, stepper motor, close to the switch, Switching itinerary, and other related component parts.
系统主要由主控制盒、电机控制盒、显示盒、步进电机、接近开关、行程开关等相关部件组成。
After each electrical equipment must have a special switch box, stop using the same switch box directly control 2 Taiwan and more than 2 sets of electrical equipment (including socket).
每台用电设备必须要有各自专用的开关箱，制止用同一个开关箱直接操控2台及2台以上用电设备(含插座)。
应用推荐