At concentration 0.25μM the mean afferent discharge rate increased 44.8±5. imp/second 30s following BK administration,32.5±3.2 imp/second 1 minute following BK administration and 20.3±3.3 imp/second 2 minute following BK administration.
缓激肽浓度为0.25μM时,平均放电频率在加药30秒后增加44.8±5.imp/second,1分钟后增加32.5±3.2 imp/second,2分钟后增加20.3±3.3 imp/second。
参考来源 - 肠炎后肠系膜传入神经敏感性变化及其机制的研究·2,447,543篇论文数据，部分数据来源于NoteExpress
Do not overheat cylinder to increase pressure or discharge rate.
禁止使钢瓶过热来增加压力或流速。
For accurate capacity measurement, use the BREAK-IN mode which complies with IEC standards (0.2c discharge rate).
如果要进行准确的电量测量，用符合IEC规范(0.2 C放电速率)的BREAK - IN模式。
Most NiMH batteries can accept discharge rate up to 3 times its capacity. A higher discharge rate will yield lower capacity.
大多数镍氢电池可以接受3倍于自身容量的放电速率。高放电速率会导致释放更少的电量。
应用推荐