其表现是：当编程／擦除这个块时，不能将某些位拉高，这会造成页编程(page program)和块擦除(block erase)操作时的错误；相应地，反映到状态寄存器(status register)的相应位。
基于4个网页-相关网页
Data-block Erase Table 数据块擦除次数表
Erase Block 擦除块 ; 而只能按擦写块
block mass erase procedure 块擦除程序
Erase Block Summary 擦除块摘要
Erase Failure block Count 擦除错误块计数
Dynamic wear leveling addresses the problem of a limited number of Erase cycles for a given block.
动态平均读写解决了块的Erase周期的次数限制。
Recall that flash devices are consumable parts: You can perform a finite number of Erase cycles on each block before the block becomes bad (and must therefore be tagged by bad block management).
前面提到flash设备属于耗损品：在变成坏块以前，可以执行有限次数的反复的Erase操作(因此必须由坏块管理进行标记)。
Here's why this could happen: the metadata update would erase any reference to the original data block(s), but would point to data block(s) on disk that were never filled with data.
出现这种情况的原因如下：元数据更新删除了对原先数据块的任何引用，却指向磁盘上没有填充过数据的数据块。
应用推荐