glass bending process 玻璃弯曲法
push-bending process 推弯工艺
Bend stretch bending process 弯管拉弯工艺
Basic Bending Process 基本弯曲流程图
Vertical Bending Process 垂直弯曲流程图
Thin-walled square tube bending process 薄壁方管折弯工艺
nc bending process 数控弯曲
pre-bending process 预弯工艺
tube bending process 弯管加工
Finite element software ANSYS was used to simulate the thin wall Ti-tube heating bending process with large diameter.
采用有限元软件ANSYS对大直径薄壁钛管加热弯曲成形过程进行了有限元模拟。
参考来源 - 大直径薄壁钛管加热弯曲成形的数值模拟·2,447,543篇论文数据,部分数据来源于NoteExpress
The spring-back is not only one of the most common defects in the sheet metal forming, but also one of the hardest to control deficiencies, especially in the bending process.
回弹是薄板冲压成形中最常见的缺陷之一,也是最难控制的缺陷,尤其是在弯曲成形过程中。
Springback is a common phenomenon in bending process. It has been proved that stretch bending can decrease the springback effectively, which can improve the forming precision.
回弹是弯曲成形中普遍存在的现象,实践证明采用拉弯工艺可以有效地减小回弹,从而达到提高成形精度的目的。
This double bender is designed to speed up the bending process of rebar.
这款双折弯机设计用于提高钢筋的弯曲工艺。
应用推荐