reverse base-emitter voltage [电子] 反向基射电压
base-emitter voltage 基射极间电压
Base-Emitter Saturation Voltage 基射极间饱和电压
base emitter junction voltage 基极射极结电压
emitter to base voltage 发射极基极电压
In the event of an overload when ILOAD exceeds its maximum permissible value, the increase in voltage across R6 results in sufficient base-emitter voltage to turn on Q2.
当iload超过最大允许值时发生过载情况,R6上的电压增大导致基极-发射极电压足够大到导通Q2。
Consequently, no load current flows through R6 because Q2, whose base-emitter voltage is now 0v, has turned off.
由于Q2的基极-发射极的电压为0 V而截止,因此没有负载电流流过r6。
When choosing a value for R6, ensure that Q2's base-emitter voltage is less than approximately 0.5V at the maximum permissible value of the load current.
选择R6的阻值时要确保在负载电流的最高允许值的条件下,Q2的基极-发射极电压大约低于0.5V。
应用推荐