First of all, the paper analysis and evaluated the mechanical properties of the raw materials ,made mixture match ratio design by laboratory test ,then confirm the parameters,just like gradation、total water consumption、optimal asphalt content and cement content。
首先对原材料性能进行分析评价,通过室内混合料配合比设计,确定混合料的级配、总用水量、泡沫(乳化)沥青用量、水泥用量等设计参数。
参考来源 - 现场冷再生混合料性能与施工技术研究Moreover, the paper uses grey entropy method to determine the primary and secondary relation of the influence of aggregate content and asphalt content to the asphalt viscoelasticity parameters and low temperature performance.
同时,论文采用灰熵法分析了各档集料和沥青含量对沥青粘弹性参数和低温性能影响的主次关系。
参考来源 - 沥青砂浆细观力学性能分析研究·2,447,543篇论文数据，部分数据来源于NoteExpress
The inspecting value of sample for asphalt content sampling of asphalt mix is normal distribution.
沥青混合料沥青含量抽样检测的样本检测值服从正态分布。
The asphalt content is one of the most important control targets in the production of the asphalt concrete.
沥青含量是沥青混凝土生产中最主要的控制指标之一。
These factors considered were asphalt content, confining pressure, temperature and frequency of dynamic force.
本文中所考虑的因素有沥青含量、应力状态、温度及动力的频率。
应用推荐