北京隆科兴非开挖工程公司 关键词： 导向强度、轨迹设计、公式验证 [gap=601]Key words : Strength-oriented, Trace Design, Formula Validation
基于6个网页-相关网页
As far as the length of the paper is concerned,we focus on one of the whole system,and the subsystem includes three modules:Well track design,well track predict and well track anti-collision.
因此,本文着重研究的是其中一个子系统——井身轨迹数据处理子系统。 这个子系统包括三个功能模块,分别是:轨迹设计、井筒防碰分析和井身轨迹预测。
参考来源 - 井身轨迹数据处理子系统的设计与实现·2,447,543篇论文数据，部分数据来源于NoteExpress
摘要：描述了基于矢量分析和NURBS的数控加工轨迹设计方法。
Abstract: a tool path generation method is presented for NC machining based on vector analysis and NURBS.
刀具运动轨迹设计质量的好坏，将直接影响零件的加工质量及加工成本。
Whether the tool path quality is good or bad will directly affect the machining and the machining cost of part.
叙述了在定向钻进的钻孔轨迹设计时，地面不平整度修正的方法与应用。
Method and its application of uneven ground modifying in directional drilling locus design are narrated in this article.
应用推荐