预测可能存在的气泡、熔接痕的位置，确定最佳浇口位置，并在此基础上设计模具。
In order to obtain the best gate location addition, the position of air bubbles and weld lines were forecasted.
预测可能存在的熔接痕位置及锁模力的大小，确定最佳浇口位置。
In order to obtain the best gate location addition, the position of weld lines and the clamp force were forecasted.
进而应用CAE软件进行分析，通过调整浇口位置，对熔接痕的长度进行优化，使其减少到最小，结果得到实践验证。
Then using CAE analysis and through adjusting the gate position, weld lines can be optimized to the minimum length, and this result has also been identified by practice.
应用推荐