压铸模设计中，根据要压铸零件支架的参数性能要求，设计定模和动模两部分。
Die-casting in the mold design according to toeing die-casting the parameter function request of the spare parts support, design to settle the mold and move two parts of mold.
对于中心位置浇口，由于产品顶出后模具配件和浇品处披锋阻碍很难去掉而造成动模与定模不能分开。
In the case of center-positioned gate, moving die is not separated from fixed die due to the interference of the biscuit part and the cutting of gate is ery difficult after pulling out the product.
在计算型腔温度时采用选代算法，同时分析注塑动模和定模。
As both the moving and the stationary parts of an injection mold should be handled simultaneously, an iterative method was used to calculate the temperature.
应用推荐