These lay foundation for the calculating software of non-interference cutter pass.
这些都为无干涉刀位轨迹计算软件的通用性奠定了基础。
参考来源 - 复杂曲面数控加工无干涉刀位轨迹的计算方法研究On basis of the previous researches, a new tool-path generation algorithm for three-axis NC rough machining based on solid models is presented. With this algorithm, the complicated calculation procedures such as profile loop offset, self-intersection and Boolean operation are avoided.
在此基础上，提出了一种适合实体模型的新的三轴数控粗加工刀位轨迹生成算法。
参考来源 - 基于实体模型的数控编程技术的研究与实现·2,447,543篇论文数据，部分数据来源于NoteExpress
该算法能直接从测量数据中生成荒加工刀位轨迹。
It generates tool paths for hogging machining directly from measured data.
本文介绍了利用最小有向距离原理计算刀位轨迹的方法。
A method of using the principle of minimal orientation-distance to calculate cutter-trace is introduced in this thesis.
文中给出了由该算法生成的带岛屿型腔刀位轨迹的实现步骤及计算实例。
This algorithm is used to generate nc tool paths for the pocket with the islands, and to obtain better efficiency and stability.
应用推荐