本文介绍了在UO_2粉末中加入造孔剂制备低密度uo_2燃枓芯块的方法。
In this paper, the method fabricating the lower density UO_2 fuel pellet is investigated.
研究了石蜡(PW)和低密度聚乙烯(LDPE)的含量、粉末装载量和脱脂方法对脱脂保形性的影响。
The influences of the content of PW and LDPE, the powder loading amount as well as the degreasing method on the shape holding in metal injection molding are investigated.
研究了石蜡（PW）和低密度聚乙烯（LDPE）的含量、粉末装载量和脱脂方法对脱脂保形性的影响。
The influences of the content of PW and LDPE, the powder loading amount as well as the degreasing method on the shape holding in metal injection molding are investigated.
应用推荐