• 流向上泄漏10额定流量系数

    In the flow, the leakage rate 10 rated flow coefficient.

    youdao

  • 齿条式连接可调节开启角度额定流量

    Rack adjustable opening Angle of connection, rated flow.

    youdao

  • 流量参数包括额定流量最大最小流量

    Table heat flow parameters including rated flow and the largest and smallest flow.

    youdao

  • 具有额定流量系数,可比大,密封效果调节性能灵敏体积,可安装等优点。

    It's with large flow coefficient and adjustable, excellent sealing, sensitivity regulate performance, small size, vertical horizontal installed.

    youdao

  • 额定放量标准状况下气体体积表示的泄压设施的体积流量

    Rated relieving capacity is the flow capacity of a relief device expressed in terms of air flow at standard conditions ( SCFH or Nm3/h).

    youdao

  • 开关柜之间线需要母线连接,提供母线桥额定流量,母线桥的跨度,距高度等具体数据。

    If using busbar bridge between switchgears or inlet wire cabinets, should provide rated current-carrying capacity, span and height from the ground of the busbar bridge.

    youdao

  • 任何一台潜水电泵铭牌上所规定流量扬程是这台潜水电泵使用额定工况,一般也是使用效率较高的最佳点。

    Submersible pump any of the provisions of the nameplate on the flow and head submersible pump is rated for use condition, the general is also more efficient use of the best point.

    youdao

  • 计算得到了额定工况标准燃料组件各个冷却剂通道流量分布不等间隙通道燃料板两侧

    The flow distribution and pressure difference of different coolant channels in the standard fuel assembly at rated operating condition are reached.

    youdao

  • 不要超过所选择水泵系统任何部件最大压力流量额定额定最低的部件决定了水泵系统的最佳可用性能

    Never exceed the maximum pressure or flow ratings of any component in your system the component with the lowest rating determines the maximum performance available from your system.

    youdao

  • 底盘上的模压箭头顶盖上树脂标签箭头必须指向流体流向。(请参阅第6了解“安装信息,参阅第7页了解“流量额定和接线信息”。)

    The stamped arrow on bottom plate mounting and top cover gum label arrow must both point in direction of flow. (See page 6 for "Installation" and page 7 for "Flow rates and wiring information.

    youdao

  • 额定放量:设计压力设计真空下,用标准状况下气体体积表示设施的体积流量

    Rated relieving capacity: The flow capacity of a relief device expressed in terms of air flow at standard conditions ( SCFH or Nm3/h) at a designated pressure or vacuum.

    youdao

  • 额定放量:设计压力设计真空下,用标准状况下气体体积表示设施的体积流量

    Rated relieving capacity: The flow capacity of a relief device expressed in terms of air flow at standard conditions ( SCFH or Nm3/h) at a designated pressure or vacuum.

    youdao

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定