提出了连续激光非晶化进一步研究的方向。
The further research direction of CW laser glazing is proposed.
研究结果表明，随着合金成分的不同，非晶化程度的影响不同。
The results showed that with the different Ni concentration, the effect of degree of amorphization was different.
结果发现，球磨可形成合金化，随球磨时间的增加，样品的非晶化逐渐加强。
The results show that an alloy may be formed by ball-milling and amorphous character is enhanced with the increasing of the milling time.
然后执行热处理步骤，以便使有缺陷的半导体晶体材料的非晶化区域再结晶。
A thermal treatment step is next performed so as to recrystallize the amorphized region of the defective semiconductor crystal material.
结果表明，晶区的非晶化转变是原丝在预氧化过程中组织结构演变的主要形式；
The results show that amorphization of crystallite is the main form of microstructural evolution during thermal stabilization of PAN fibers.
XRD和SEM分析表明： 球磨后合金颗粒粒径减小， 且有明显的非晶化趋势；
XRD and SEM analysis indicate that the modified alloy is amorphized to some extent besides of the reduction of particle size.
提供了一种方法，其中，对有缺陷的半导体晶体材料执行非晶化步骤，随之以热处理步骤。
A method in which a defective semiconductor crystal material is subjected to an amorphization step followed by a thermal treatment step is provided.
在相同的球料比的条件下，提高球磨转速，可以大大促进非晶化的形成过程，缩短非晶形成的时间。
At the same weight ratio of ball-to-powder, enhancing the velocity of milling could accelerate the amorphization process.
研究结果表明：喷雾干燥法制得的复合氧化物粉末各种组元是在原子水平上的均匀混合，且非晶化程度高；
The results show that all compositions of the powder are uniformally mixed at atom level and have a high non-crystallizing degree.
这些参数之间的变化关系符合直接碰撞导致非晶化模型，即每一个注入离子由于级联碰撞使表面局部的小区域非晶化。
The variation relations between these parameters are found to agree well with direct impact amorphisation model in which each projectileamorphises a logical region by cascade effect.
因此，在非晶的机械晶化过程中需要考虑压力的作用。
Therefore, the effect of the pressure should be taken into account in the mechanical crystallization of amorphous materials.
该非晶合金出现晶化的温度随热处理时间的增长而降低。
It has been found that as the heating time increases, the crystallization temperature of the amorphous alloy will decrease.
通过对非晶态样品的热分析，确定了它的晶化温度、玻璃转变温度和低温弛豫温度。
The thermal analysis was used to determine the crystallization temperature, the glass transformation temperature and low temperature relaxation temperature of the amorphous samples.
非晶合金(金属化玻璃)是一种优异的低损耗软磁材料。
Amorphous alloy is a excellent soft-magnetic material which has lower losses.
对非晶合金电沉积镀层的晶化温度和硬度进行了测定。
The crystalline temperature and the hardness of the amorphous electro-depositional coating were determined.
不同球磨条件下的产物含有的非晶相的晶化温度比单一非晶相合金的晶化温度稍高，并且与球磨条件以及成分的关系不大。
The crystallization temperatures of amorphous phases in the products are higher than those of amorphous alloys with single phase, and hardly independent of the milling conditions and the composition.
射线衍射和透射电子显微镜实验不但证实它的非晶性，而且给出它的平均颗粒度大小和晶化产物。
X-ray diffraction and transmission electron microscope experiments indicate the powder sample is amorphous and also show the average particle size and crystallization products.
因此，晶化动力学成为非晶合金研究领域的热点之一。
Therefore, the crystallization kinetics become one of the hottest fields in research of amorphous alloys.
观察到非晶合金的晶化温度，磁有序温度和平均磁超精细场有规律性的变化。
The regular variation of crystallization temperature, magnetic ordering temperature and average hyperfine magnetic field of the amorphous alloys with Nb content were observed.
玻璃衬底与非晶硅膜之间的非晶氮化硅膜对非晶硅膜的晶化没有明显影响。
The amorphous silicon nitride film between amorphous silicon film and glass substrate is found to have no any effects on the crystallization.
本文从非晶中原子扩散激活能可变化的观点出发，对弛豫过程中元素再分布和脆化机制进行了讨论。
The mechanism of elementary redistrib utionand annealing embrittlement during relaxation Was discussed on the viewpoint ofthe activation energy of atomic diffusion in Ni-P amorphous being variables.
介绍了一种非晶硅薄膜低温晶化的新工艺———金属诱导非晶硅薄膜低温晶化。
We developed a new process for low temperature crystallization of amorphous silicon films, by metal induced crystallization of amorphous silicon films at low temperature.
本论文以铜锆基大块非晶合金为研究对象，研究了其非晶形成能力、晶化行为和力学性能。
The glass forming ability, the behavior of crystallization and mechanical properties of the Cu-Zr-based bulk metallic glasses have been investigated.
探讨了脉冲电流对大块非晶合金的结构驰豫和晶化转变行为的影响。
The influence of high-density pulsing current on the structural relaxation and crystallization behavior has been discussed.
此外，纳米碳管的加入，使镀层由非晶变成了纳米晶，促进了复合镀层的晶化。
Moreover, adding carbon nanotubes not only improves the degree of crystallization for the composite deposit but also helps their transformation from the amorphous state to the nanocrystal state.
利用X射线衍射仪和示差扫描量热计（DSC），研究该非晶薄带的非晶特性及晶化过程；
The amorphous ribbons and their crystallization processes were identified by differential scanning calorimeter (DSC) and X-ray diffraction (XRD).
简述了机械合金化（MA）制备非晶的特征。
The characteristic of amorphous phase synthesized by mechanical alloying(MA) was reviewed.
热处理后，当非晶合金中出现分离相或晶化析出相时，压缩强度将急剧下降。
The compression strength of heat treated amorphous alloy is decreased remarkably due to the occurrence of precipitated phase or crystallization phase in the amorphous alloy.
热处理后，当非晶合金中出现分离相或晶化析出相时，压缩强度将急剧下降。
The compression strength of heat treated amorphous alloy is decreased remarkably due to the occurrence of precipitated phase or crystallization phase in the amorphous alloy.
应用推荐