阀门弹簧和液压弹簧分获2004年中国机械通用零部件工业协会优秀新产品特等奖和优秀奖。
Valve spring series won the excellent new products prizes in 2004 China General Machine Components Industry Association. Hydraulic pressure spring won excellent prizes meanwhile.
由于这种止回阀能够在重力和介质倒流撞击启闭件之前关闭阀门,因此这种直通弹簧驱动升降式止回阀也称为“静音”止回阀。
The in-line spring-actuated lift check also is referred to as the "silent check" because the spring closes the valve before gravity and fluid reversal can slam the valve closed.
安装一根粗弹簧就可以达到迅速关闭阀门的目的。
Rapid closing of the valve is accomplished fitting a heavy spring.
表中,最小弹簧扭矩即为关闭阀门时的扭矩,最大弹簧扭矩即为打开阀门时的扭矩。
Table, the minimum time to close the valve spring torque is the torque, maximum torque is to open the valve spring torque.
调整阀门的开关速度主要调整阀门的弹簧压力。弹簧压力增加,则阀门的开关速度加快。
The switching speed of the upper and lower valves can be adjusted by regulating the spring force of them.
此类阀门利用气压和弹簧压力操作。
These valves use air pressure and spring pressure to operate.
金属横膈膜在阀门的顶部作为密封。这一代阀门的主要的改进是取消了用于开启阀门的弹簧。
The metal diaphragms act as the seal at the top of the valve. The primary improvement in this generation of valves is the elimination of the spring used to open the valve.
弹簧能够使阀门保持在正常流量位置。
同时,可以利用调整阀瓣的自重、弹簧的弹力以及阀瓣的底孔大小来确定阀门的开启压力和启闭时间。
Meanwhile, the flap valve can be used to adjust weight, spring tension and the bottom outlet valve flap valve opening size to determine the pressure and open and close time.
阀门泄漏量符合ANSIB16.104标准,调节阀配用不同的多弹簧执行机构,输出力大。
Valve leakage and conforms to the ANSIB16.104 standard, valve equipped with multi spring actuator different, large output force.
这意味着操作机构必须离阀门足够远以允许阀门通过气门弹簧使其完全关闭。
This means that the operating mechanism must be able to move sufficiently far enough away from the valve to allow the valves to be fully closed against its seat by the valve spring.
由于弹簧材料钢性大不能用不锈钢球阀等防腐材料制作,产品防腐能力差,阀门的使用寿命不长。
As the largest steel spring material such as stainless steel anti-corrosion materials can not be produced, poor corrosion products, the life of the valve is not long.
调整阀门的弹簧压力大小,应通过试灌装计量及操作人员的经验来确定。
The switching speed increases with the spring force. The adjustment of the spring force of the valves shall be determined by trial filing metering and the experience of operator.
液体从系统中被排出时,系统压力降低,直到在弹簧压力作用下阀门回复原位。
As fluid is released the system pressure decreases until the spring force re-seats the poppet.
弹簧受压差的作用自动控制阀胆上过流面积的大小,从而使通过阀门的流量恒定。
The role of compression springs bad gall on automatic control valve flow area of the size, so that a constant flow through the valve.
这种阀门应该是黄铜阀体,不锈钢阀杆和弹簧。
Valve shall have a brass body and stainless steel stem and spring.
当阀门出口压力降到导阀弹簧设定压力时,导阀开启,控制室向下游排水。
When the valve outlet pressure to a pilot valve spring set pressure, pilot valve opens, the control room to the downstream drainage.
春季返回气动执行机构使用的空气供应,以推动一个方向阀杆和一个内部装载弹簧返回到原来的位置阀门。
The spring return pneumatic actuators use an air supply to drive the valve stem in one direction and an internally loaded spring to return to the valve to its original position.
断电时,辅阀利用弹簧力或介质压力推动关闭件,向下移动便阀门关闭。
The high pressure around the valve off, fluid pressure to promote the closure of parts moving down, close the valve.
有些类型止回阀配置弹簧驱动,能够在流动停止时,立即关闭阀门。
Some styles are spring-actuated for immediate closure when flow stops.
阀的水路转换机构由推杆、弹簧、弹簧座、阀门塞等组成。
The water path switching mechanism of the valve is composed of a push rod, a spring, a spring seat, a valve plug, etc.
快开阀门上最好自带一个自动回位弹簧,松手即刻关闭。
The quick-opening valve is better provided with an automatic return spring so as to close the valve after being released.
快开阀门上最好自带一个自动回位弹簧,松手即刻关闭。
The quick-opening valve is better provided with an automatic return spring so as to close the valve after being released.
应用推荐