合销必须足够短，以便在使用中能更易于模具的拆卸和安装。
Dowel pins need to be short to allow easier dis-assembly and assembly of the mould during use.
针对这一问题，本文研究了零件加工误差对动模板合模位置的影响，得出了零件加工误差的许用值范围，并计算了由于销轴摩擦力对合模力放大比的影响关系式。
Aiming at these problems, this paper studies how the original error affects the accuracy, works out its allowable values, and finds out the equation between friction of pins and clamping force.
开端的导轨应热处理，一边用合销固定，另外一侧应为可调的。
Beginning guide rails should be hardened and doweled on one side and the other side should be adjustable.
只要可能，在分流式系统上应提供螺丝及合销孔。
Where possible screw and dowel hole clearance will be provided in the manifold.
孔不在中心的压配合嵌套必须使用合销或扁平健固定其位置，因空间要求合销定位是首选。
Press fit buttons with other than centered round holes will use dowel locator for position or flat key. Dowel locators are preferred due to space requirements.
孔不在中心的压配合嵌套必须使用合销或扁平健固定其位置，因空间要求合销定位是首选。
Press fit buttons with other than centered round holes will use dowel locator for position or flat key. Dowel locators are preferred due to space requirements.
应用推荐