并将移动平台视为广义运动副,利用速度叠加原理完成了雅可比矩阵的求解。
And it also got Jacobian matrix by using the speed superposition principle through regarding mobile platform as Generalized Kinematic Pair.
本文的主要研究工作就是叠加速度分析和奇异性检测。
This thesis is about the research of stack velocity analysis and singularity detection.
将这一结果应用于P-SV转换波的速度分析和叠加处理中。
The result is applied to analysis of velocity and stacking of the P-SV converted-wave.
文中介绍了“叠加速度与剩余静校正量的迭代计算”的基本原理、实现过程和效果分析。
This paper introduces the principle and implementation of iterative computation of stacking velocity and residual statics and discusses its application effects.
本文讨论了均匀介质情况下非零炮检距菲涅耳带和动校、叠加中速度误差对纵向分辨率的影响这两个问题。
This paper deals with two problems, nonzero -offset Fresnel zone in homogeneous media, and the effect of velocity error resulted in NMO correction and stacking on vertical resolution.
然后对该道集进行速度分析、动校正和叠加,得到偏移地震剖面,即共散射点成像。
Then the trace gather undergoes velocity analysis, normal moveout correction and stack to bring seismic migrated section ( This is called scattering point imaging).
本文提出的基于起伏地表的叠加速度分析方法,应用双平方根方程计算反射波的旅行时间,可适用于地形起伏剧烈地区。
The method of stack velocity analysis based on relief surface presented in the paper uses double-square-root equation to compute the travel time of reflections, which is suitable to use in the area w.
如果选择不同的基准面,相应的速度分析和叠加结果也会不同。
If selecting different datum, the corresponding results of velocity analysis and stack are different too.
利用这8个校正公式校正叠加速度的最大相对误差均小于1.5%。
The biggest relative error is less than 1.5% when they are used to adjust the stack velocity.
针对浅层地震资料目的层较浅、叠加次数少和城市背景干扰大等特点,文中对速度分析的参数选取问题进行了研究。
Considering the properties of low stack folds, shallow objected layers and big background noise of shallow seismic data, the parameters selection for velocity analysis is studied in the paper.
实际处理表明,该技术能进一步提高叠加速度的精度,改善构造复杂区或速度横向变化较大时的叠加成像。
The case study shows that using this technique can be able to further improve the precision of stacking velocity and imaging in complex structural areas or with big variation of lateral velocity.
根据动量叠加原理对多股等羽流的相互作用进行了研究,定义了三个速度修正系数和流量修正系数。
Researches the interaction of the multiple equal plumes based on the principle of momentum congruence. Defines three velocity correction coefficients and a flow rate correction coefficient.
而速度分析则是为叠加提供最佳的叠加速度。
Velocity analysis provides the best stack velocity for stacking.
常规动校正处理方法提供的叠加速度及层速度精度不能满足钻前压力预测的需要。
The precision of stack velocity and interval velocity provided by common NMO correction processing method can't meet the need of predicting the pre-drilling press.
采用同炮检距道集进行迭代叠加和乘模型系数道叠加,可以提高速度分析的精度。
The velocity analysis accuracy may be raised by applying iterative stacking method and multiplying model trace stacking method to common-range gathers.
由于动校正速度是随偏移距变化而变化的,而常规速度分析并没有考虑这一因素,动校正效果往往不是很理想,从而影响资料的叠加和成像效果。
The conventional velocity analysis does not consider the influence of the NMO velocity varying with offset, making the results not ideal, leading to a poor stacking and migration imaging.
移动速度效果不与其它效果叠加。
This speed does not stack with other movement speed increasing effects.
在此浮动基准面上求取的叠加速度仅取决于低速带底板下伏介质的速度,而与地形、低速带无关。
The stack velocity calculated on the floating datum depends on the velocity of medium underlying the low velocity layer and is independent of topography and low velocity layer.
在地形起伏剧烈和表层低速带速度横向变化较大的地区,做好野外静校正是取得高质量叠加剖面的重要一步,而确定表层低速带速度是做好静校正的关键。
Field statics is one of vital processing for achieving high quality stacked sections in areas with drastic topographic relief and sharp lateral variations of LVZ velocity.
设粘弹性板的轴向运动速度为常平均速度与简谐涨落的叠加,建立轴向加速运动粘弹性矩形薄板的运动微分方程。
The axially moving speed is a simple harmonic fluctuation about a constant mean speed, the differential equation of motion of axially accelerating viscoelastic plate is established.
若使共中心点道集内的反射同相轴校平后能够同相叠加, 叠加速度则会出现一些低或高的异常。
In order to in-phase stack of aligned reflection events on CMP gathers, the stack velocities may have some higher or lower anomalies.
利用开阀速度和开阀压力建立油气弹簧节流缝隙设计公式,并对叠加阀片和调整垫圈对节流缝隙的影响进行了分析。
The design formula of throttle aperture of hydro-pneumatic spring was established according to the relationship between pressure and flux.
在快速变向或变速过程中,车手受到的外力是多项作用力叠加的结果,一般以一个重力加速度为单位。
A physical force equivalent to one unit of gravity that is multiplied during rapid changes of direction or velocity.
在快速变向或变速过程中,车手受到的外力是多项作用力叠加的结果,一般以一个重力加速度为单位。
A physical force equivalent to one unit of gravity that is multiplied during rapid changes of direction or velocity.
应用推荐