用伏特表测量红色接头处的熔断点火装置开关输出电路。
Using a voltmeter measure fused ign sw output ckt at the red conn.
双反星型，平衡电抗器及平波输出电路，焊接电流稳定。
Double reversed star shape, interphase reactor, flat wave output circuit, stable welding current.
图1所示的电路，既适用于输入电路，又适用于输出电路。
The circuit shown in Fig 1. can apply to either input or output circuit.
乘法电路的输出端通过继电器或输出电路连接除雾控制开关。
The output end of the multiplying circuit is connected with the demisting control switch through the relay or the output circuit.
解决上述问题的方法是自动控制输出电路MOS管的栅极电压变化率。
This problem can be solved by controlling the variety speed of the G-S(grid-source) voltage of MOS transistors.
它由传感器、信号放大电路、比较输出电路、延时电路和可控硅组成。
The utility model is composed of a sensor, a signal amplification circuit, a comparison output circuit, a delay circuit and controllable silicon.
本文分析CCLID浮置扩散放大器（FDA）输出电路的输出电压波形。
This paper analyses the output voltage waveform of the CCLID with floating diffusion amplifier (FDA) output circuit and proposes the concept of "reset inefficiency".
通过外部的输出电路，把产生的主轴a、B、Z脉冲发送到被测的数控系统。
Through the exportation electric circuit of the exterior, the principal axis a, B, Z pulse was sent out to the measured numerical control system.
传统的D类放大器一般由三部分组成，即调制电路、驱动电路和功率输出电路。
The traditional class D amplifier is composed of three parts: modulation circuit, driving circuit and power amplification circuit.
电路包括存储阵列、译码电路、敏感放大器、数据输入输出电路，预充电电路等部分。
The whole circuit includes memory array, decode, sense amplifier, data in - out circuit and pre - charge circuit.
硬件系统主要包括速度检测电路、电流检测电路、PWM输出电路、DSP外部电路。
The hardware system includes the speed measurement circuit, current measurement circuit, PWM drive circuit and DSP exterior circuit.
同时对继电器类型的输出装置进行了分析和研究，设计出适合本系统的继电器输出电路。
Meanwhile, the relay is one of the output devices. After analyzing its characteristic, we have worked out the corresponding output circuit.
本文介绍目前常用的电压可调集成稳压器LM 317实用电路，着重在高压输出电路方面。
The paper introduces a adjust voltage integration regulator LM317 in common use, this kind of utility circuit emphasize the sides of high voltage output circuit.
为改善伺服阀的特性，在系统各通道的伺服输出电路中增加了可程控的阀偏置和阀颤振电路。
There are valve dither and valve set point circuit to improve the performance of the system.
给出了一个简洁的单片机控制电路，分析了输出地址，描述了不同类型的输出电路和输入电路；
A succinct SCM control circuit was pre-sented. Output address of the circuit was analyzed. And various input or output circuits were also described.
最后，本文讨论了控制系统中用到的开关量的输入和输出电路的设计，并给出了具体的应用电路。
Finally, the cue of the design for switching value input and output interface circuits was given, and then a circuit in accordance with the thought of the design produced.
系统硬件包括按钮开关输入电路、七段数码管输出电路、加热电路、升压电路以及波形控制产生电路。
The system hardware includes switch input circuit, seven segments LED output circuit, heating circuit and boost circuit.
电源系统硬件主要由电压和频率控制电路、相关电压处理电路、频率处理电路以及综合输出电路组成；
The hardware of the power supply is mainly composed of voltage and frequency circuits, related voltage processing circuit, frequency processing circuit, and integrated output circuit.
本系统由FPGA、单片机控制模块、键盘、LCD液晶显示屏、DAC输出电路和末级放大电路构成。
Abstrat: This system is composed by FPGA, MCU controller, keyboard, LCD, DAC and amplifier modules.
高压硅堆是彩电和彩色显示器行输出电路中的关键器件，其开关速度的快慢直接限制了行扫描频率的高低。
High voltage silicon pile is the key component of the output circuits of color TV and color monitor, whose switch frequency is the direct restrictive factor of line scan.
输出电路对于该第一输出信号和该第二输出信号执行逻辑运算，并且输出该逻辑运算的结果作为结果信号。
An output circuit performs a logic operation on the first output signal and the second output signal, and outputs a result of the logic operation as a resultant signal.
电源系统硬件部分主要包括整流滤波电路、调压及逆变电路、驱动及控制电路、输出电路、辅助保护电路等。
The hardware system mainly includes rectifier and filter circuit, regulate voltage and inverter circuit, drive and control circuit, output circuit, protection circuit etc.
在硬件系统中，主要介绍了励磁电路、信号处理电路、人机接口、信号输入输出电路及空管检测电路等几个部分。
In the hardware system, mainly introduced the exciting circuit, signal processing circuit, man-machine interfaces, signal input and output circuits and the method of empty pipe detection.
对DSP的输出电路、独具特色的键盘显示电路、高精度的检测电路和可靠的保护电路进行了分析，并给出了软件设计。
DSP's output circuit, keyboard and display circuit, high precision measure circuit and credibility protect circuit are analyzed, and the software design is given.
本控制系统以高性能8位单片机at89c52为核心，结合数据采集电路、信号输出电路、实时时钟电路、系统监控电路组成。
The control system is composed of AT89C52, a high-powered 8-bit microcontroller, data gathering circuit, real time circuit, data output circuit and system watch circuit.
硬件上详细给出了系统主要功能模块的工作原理和设计内容，包括模拟信号输入电路、数字信号输入输出电路、看门狗及系统复位电路等。
On the hardware design we provide the operation principle of the main function module and design content in detail, including Analog Inputting, Digital Inputting and Outputting, Watchdog, etc.
论文通过对全波整流输出电路与其他副边整流电路的比较，得出采用全波整流电路特别适合隔离型低压、大电流输出的DC／DC变换器的结论。
Compared to the other second-side rectifier, it is concluded that the full-wave Rectifier is well adapted to the Low-voltage High-current DC-DC converter.
文中提出了一种用于PWM控制器的比较器输出电路的设计，该电路基于电流模式控制，能够同时对三路输入信号进行比较输出并对输出信号进行锁存。
A comparator circuit based on current-mode control used in PWM controller is presented that is able to compare 3-data at a time and latch output signals.
文中提出了一种用于PWM控制器的比较器输出电路的设计，该电路基于电流模式控制，能够同时对三路输入信号进行比较输出并对输出信号进行锁存。
A comparator circuit based on current-mode control used in PWM controller is presented that is able to compare 3-data at a time and latch output signals.
应用推荐