输送皂角泵内有设计合理的泄油和回油槽，是齿轮在工作中承受的扭矩力最小，因此轴承负荷小，磨损小，泵效率高。
Pump is the drainage and back into the groove of reasonable design, is a gear in the work under the minimum torque force, so the bearing load is small, wear small, pump with high efficiency.
轴承的油槽要滚铣和倒角。
在测量油膜轴承锥套内部圆度误差过程中，由于内表面有许多油槽和油孔，测量过程中产生了大量无效数据。
In the roundness error measurement of inside sections of the oil film bearing, because of the oil slots and the oil holes, a large amount of invalid data can be brought.
外球面球轴承外圈一般带油槽，也生产外圈无油槽的产品。
Usually, the outer ring of the tl bearings has grease groove, bearings having no grease groove are to be provided, too.
泵内有设计合理的泄油和回油槽，是齿轮在工作中承受的扭矩力最小，因此轴承负荷小，磨损小，泵效率高。
There are well-designed pump drain back tank and is exposed in the work gear torque exerted the smallest, so bearing loads of small, wear, pump efficiency.
泵内有设计合理的泄油和回油槽，是齿轮在工作中承受的扭矩力最小，因此轴承负荷小，磨损小，泵效率高。
Pump discharge of oil with reasonable design, gear oil and back at work under minimum torque force bearing load, so small, wear small, pump with high efficiency.
泵内有设计合理的泄油和回油槽，是齿轮在工作中承受的扭矩力最小，因此轴承负荷小，磨损小，泵效率高。
Pump is the drainage and back into the groove of reasonable design, is a gear in the work under the minimum torque force, so the bearing load is small, wear small, pump with high efficiency.
泵内有设计合理的泄油和回油槽，是齿轮在工作中承受的扭矩力最小，因此轴承负荷小，磨损小，泵效率高。
Pump is the drainage and back into the groove of reasonable design, is a gear in the work under the minimum torque force, so the bearing load is small, wear small, pump with high efficiency.
应用推荐