高于阀值时,SFR随表面密度线性增长。
Above that threshold, the SFR increases linearly with that surface density.
一个星系团中星系的表面密度可从其照片上测得。
The surface density of galaxies in a cluster can be measured from photographs.
更重要的是,其表面电荷密度可以通过简单方式改变。
Moreover, the surface charge density of lipidic nanostructures can be varied in a simple manner.
在这个最简单的装置里,电流的大小表明了样品表面电子的密度,并能绘制出来。
In the simplest setup, the size of the current reveals the density of electrons in the surface, allowing it to be mapped out.
Ni:指i区的平均人口密度,为了简化分析,地球表面被按照网格分成多个i区,每个区的分布假定是统一的。
Ni : Average population density in area i. To simplify the analysis, Earth’s surface is divided into a grid of squares i, and the distribution is assumed to be uniform in each.
在电铸过程中,电铸阳极的轮廓和位置决定了阴极表面电流密度的分布,并最终影响电铸层的均匀性。
During the electroforming, the current density distribution on the cathode surface is decided by the anode profile and its position, which will influence the uniformity of the deposit finally.
瘤细胞表面的抗原密度影响细胞毒的敏感性。
Antigen density on the tumor cell surface influences the cytotoxic sensitivity.
零件表面能被低熔点金属渗透以增大密度、强度、硬度、延展性和抗冲击能力。
A part surface can be infiltrated with a low melting point metal to increase density, strength, hardness, ductility and impact resistance.
本文研究考虑损伤时材料的断裂应力,推导出了在表面能密度有限的情况下,损伤断裂应力的计算公式。
In the case of the limited level density of the material surface energy, the fracture stress and the calculation formula of the engineering damage were studied.
随着硅片表面电荷密度增加,BSA吸附量增加。
As the surface charge density increased, the adsorbed BSA amount also increased.
对直流TIG电弧阳极板表面电流密度的测量方法——分离极板法和探针(自制)法进行了分析比较。
The measuring methods of D C TIG welding arc anode sheet surface current density split sheet method and probe (made by ourselves) method were analysed and compared.
提高表面膜的致密度,是降低氧化反应的根本措施。
Increasing the consistency of surface film is the basic measure of decreasing oxidation reaction.
结果:研究发现癌细胞与正常细胞比较,线粒体和溶酶体的比表面、数密度均减小。
Results: Compared with those of normal cell, the specific surface and numerical density of the mitochondrion and the lysosome in the mid and late stage were decreased.
菌细胞密度、表面接触和生理学信号均可成为群集运动的刺激因素。
Bacterial density, surface contact and physiological signals are stimulating factors of swarming motility.
红外探测实践表明,地质构造引起的岩石密度变化是影响岩石表面红外辐射分布的主导因素。
Infrared survey practice showed that the rock density change aroused by geological structure is the leading factor that affects rock body surface infrared radiation distribution.
激光作为一种精密可控的高能量密度的热源,可对金属表面进行多种强化处理。
Laser as a heating source of high energy density of accurate control, can carry out multiple-sort strengthening treatment to the metal surface.
借由测量无线电波的折射,我们可以描绘出冥王星大气层(从高空一直到表面)的温度与密度分布轮廓。
By measuring the refraction of this radio beam, we will be able to plot the temperature and density profile of Pluto's atmosphere from high altitude down to the surface.
电流密度对铸层表面形态有较大的影响。
考察了活性炭的失重率、堆密度、比表面、孔径分布及灰分含量随活化次数的增加而变化的情况。
The variation of the mass loss, packing density, surface area, distribution of pore diameter, amount of ash with the cyclical Numbers were researched.
当表面复合速率和体缺陷密度较大时,纳米柱的长度不宜过大。
When the surface hole recombination velocity and defect density is bigger, the length of nanowire should not be too long.
超过此密度后,微波场在表面快速衰减,气体电离主要在表面进行。
Above this density, microwave field will damp rapidly, so the gas ionization is mainly on the surface.
当体系中浆液密度较高时,颗粒由于相互间的碰撞在表面能的作用下团聚成纺锤形的大颗粒。
When density of precipitated slurry is too high, because of the collision among particles, big spindly aggregates which are made of ultra-fines are born in reactor at the action of surface energy.
嵌入式无源元件技术能够实现对电容、电感等无源元件在印刷线路板内部的嵌入式封装,从而节省线路板表面空间、提高封装密度。
The embedded passive technology can save the real estate on the surface of the printed-circuits-boards (PCBs) by embedding the capacitors and inductors inside the PCBs.
电铸阳极的形状和位置决定了阴极表面电流密度的分布,并最终影响金属沉积层分布的均匀性及其材料性能。
In the electroforming process, the anode electrode shape and position determine the current density distribution on the cathode and so the distribution and properties of the deposited metal.
采用SEM、X射线、光学显微镜、显微硬度计等手段研究了高能密度光束表面合金化的机理和工艺。
In this paper the mechanism and process of light beam surface alloying were investigated by SEM, X-ray diffraction, optical microscope, microhardness etc.
综述了扫描电镜在印制板行业中的应用前景,介绍了扫描电镜在高精度和高密度PCB板中的层压工艺、基板材料、表面涂覆及其它一些方面的应用。
The article summarizes the application prospect of the SEM in PCB and introduces the application of the SEM in the laminated craftwork, substrate material, surface processing and other aspects.
随着激光能量密度的增加,声表面波的幅度由线性变化转换为非线性变化。
With the increase of the incident power density, the amplitude of SAW changes from linear to nonlinear.
研究了热处理对气凝胶密度、比表面、微观结构和疏水性等的影响。
And we study the effects of heat-treated process on the aerogels' density, specific area, microstructure, hydrophobic property and so on.
不同浆种的纤维形态特征和表面电荷密度的差异可解释上述结果。
These results may be explained by the differences in morphology properties and surface charge densities of the pulps.
目的探讨螺旋CT多平面重建(MPR)、表面遮盖显示法(SSD)及最大密度投影法(MIP)在骨盆骨折诊断中的价值。
Objective To evaluate the diagnostic value of multiplanar reconstruction (MPR), shaded surface display (SSD) and maximum intensity projection (MIP) of spiral ct for pelvis fractures.
应用推荐