明流反弧段是容易发生空蚀的部位。
The place downstream of bucket in an open channel is easily subject to cavitation damages.
然而，这也增加了其发生点蚀的可能。
However, the possibility of occurrence of pitting is also increased.
由于其耐酸性很差，不能用于有酸蚀的场所。
Acid resistance due to its poor, can not be used for etching of the places there.
任何船只上的涂料体系都是抗蚀的第一道屏障。
The paint system on any boat is an important first barrier against corrosion.
介绍了在生产中励磁开关主触头烧蚀的解决方法。
This paper presents solution of main contact ablation of a excitation switch in production.
研究了高功率气体火花开关电极烧蚀的基本物理过程。
The basic physical mechanisms of the electrode erosion process of high power gas switches were also studied.
比较了几种测定熔蚀的方法，其中以丁字接头为最好。
Different ways of erosion measurement were also compared with each other and the T-type joint method is the best one.
研究表明：高温熔损和高温氧化是衬套受蚀的主要原因。
The results shows that melting and oxidation are the main reason of corrosion at the high temperature.
本文给出二维加热且具有表面烧蚀的发汗控制数学模型。
This paper represents a mathematical model of transpiration cooling control system with two-dimensional heating and surface ablating.
铬含量、温度和氯化物浓度对蒸汽轮机叶片钢点蚀的影响。
Pitting corrosion of steam turbine blading steels: the influence of chromium content, temperature, and chloride lon concentration.
运用最小自由能原理，研究了超高温热化学烧蚀的计算方法。
The principle of minimum free energy method was analyzed. The calculation method of thermal chemical ablation was studed.
该类缓蚀剂制备工艺简单，从而降低了在海水中铜缓蚀的成本。
The preparation process of the inhibitor is very simple, and thus beneficial to decreasing the cost of corrosion inhibitor for copper.
本文研制了一种耐酸蚀的封孔剂并对封孔材料的配比进行了优化。
In the article, an sealant with corrosion resistance was developed, and its sealing allocated parameters were optimized.
去膜表面发生点蚀的临界电位低于膜覆盖表面发生点蚀的临界电位。
The pitting critical potential of the fresh surface is lower than that of the surface covered by passive film.
本文对有泰氟隆烧蚀的化学非平衡粘性激波层流场进行了数值模拟。
The chemical non equilibrium viscous shock layer flows over a teflon ablative wall are calculated numerically.
最终应用于指导生产，也为钎焊熔蚀的进一步探讨提供了理论基础。
Ultimately, it is used to guide the production and provides a theoretical basis for the further study on the erosion during brazing.
本文对国内外脉冲激光烧蚀的气体动力学理论研究成果进行了系统论述。
In this article, the gas dynamic models of the pulsed laser ablation plume have been reviewed.
研究了X70钢在磷酸盐缓冲溶液中的亚稳态与稳态孔蚀的电化学行为特征。
The electrochemical characteristics of pitting corrosion of X70 pipeline steel in phosphate buffer solution were studied in this paper.
被高能聚焦超声烧蚀的15个肿块，10显示完全的，均一的烧蚀整个肿块。
Of the 15 tumors removed after HIFU 10 showed complete, homogeneous ablation of the entire tumor.
文章分析了电接点压力表触头烧蚀的原因，提出了无触点式压力表的改进方法。
In this article, the author analysed the cause of arc tip pressure meter scorched, an improved method for contactless pressure meter.
文章在分析135系列柴油机缸套穴蚀原因的基础上，给出了消除穴蚀的方案。
In the article, the reasons for cavitation erosion in cylinder sleeve of 135s diesel engine are analyzed, and several Suggestions to against cavitation erosion are given.
分析了柴油发动机湿式气缸套磨损及穴蚀的特点和原因，提出了相应的预防措施。
This paper analyses on the features and causes of the wear and cave - like corrosion on diesel motor's wet cylinder liner, and puts forward some corresponding preventive measures.
火龙陶瓷纤维毯的性能不受油蚀的影响，经过烘干即可恢复其热性能和物理特性。
Huolong Ceramic Fiber Blanket have excellent capability of resisting the oil, after being dried it will repossess the thermal characteristic and the physical feature.
凝汽器304不锈钢管发生点蚀的主要原因是不锈钢管质量不合格和使用的酸洗液不当。
The major causes of pitting in the 304 stainless steel tubes for condenser are that the quality of the stainless steel tube is unsatisfactory and the acid solution is unsuitable.
综述了镀锌层黑钝化、着色、染色等黑化处理的方法，重点研究了高抗蚀的黑钝化处理。
The existing methods of zinc plating blackening by black passivating, coloring, dyeing, etc. are studied, and the high resistance to corrosion of the passivator is highlighted.
点腐蚀试验结果表明，在整个试验过程中，钎料表面表现为均匀腐蚀，点蚀的迹象不明显。
Point corrosion testing indicated that there is not point corrosion mark, and uniform corrosion characteristic was present to the filler metal.
文中提出了外加控制磁场减少轨道炮炮膛烧蚀的方法，并进行了相应的机理分析和试验研究。
Reducing erosion of rail electrode surfaces with an external magnetic field control is put in this paper, and the study has also been investigated theoretically and experimentally.
而黄铜板的腐蚀形貌以表面颜色逐渐变红、腐蚀产物的增加、点蚀的增加、严重的晶界腐蚀为主。
The surface morphology of brass plate was changed too, the color of brass gradually turned red, the corrosion products and pitting increased, obvious intergranular corrosion appeared.
而黄铜板的腐蚀形貌以表面颜色逐渐变红、腐蚀产物的增加、点蚀的增加、严重的晶界腐蚀为主。
The surface morphology of brass plate was changed too, the color of brass gradually turned red, the corrosion products and pitting increased, obvious intergranular corrosion appeared.
应用推荐