另一种常见电阻是薄膜电阻。
电器触点间的接触电阻包括收缩电阻和薄膜电阻。
The contact resistance between contacts is composed of contraction resistance and velamen resistance.
随硫化温度升高及硫化时间延长,薄膜电阻率上升。
Increasing sulfidation temperature and time can enhance the resistivity of the pyrite films.
四探针测量金属薄膜电阻率是当今微电子技术领域中常用的方法。
A measurement of resistivity of metal film using four-point probe technique can be used as the general physics experiment.
热敏薄膜电阻制备是非致冷微测辐射热计红外焦平面的一项关键技术。
Preparation of thermal sensitive thin film resistor is one of key technologies in uncooled micro bolometer IR FPA fabrication.
薄膜电阻率随退火温度的变化行为与薄膜微观结构的变化以及界面扩散有关。
The annealing behavior of the resistivity is correlated with the microstructure and interfacial diffusion of the films.
本文对微电子固体薄膜结构,以及影响薄膜电阻导电性和稳定性的因素进行了研究和分析。
This paper study and analysis microelectronic solid film construction and factor that effect the film resistor conductivity and constantity.
这一现象的发现对我们今后在集成电路镍铬合金薄膜电阻的设计优化方面具有较高的参考意义。
In the process of manufacturing Ni-Cr alloy filmresistances of IC by using magnetronic sputtering, the film resistive property has been found having a regular change after annealing process.
实验结果表明:退火后样品的薄膜电阻率显著减小,是未退火样品薄膜电阻率的3.17分之一;
The experimental results indicated that the film resistivity of the sample annealed was reduced significantly and only one 3.17 of the unannealed.
指出利用沉积有网格图形的钽薄膜电阻的匹配衰减网络作微波吸收体,可以获得比较好的宽带性能。
It is shown that the better broad band performance can be obtained using the matched attenuation network formed by depositing ta film resistor, as a microwave absorbent, with grid pattern.
公司主要产品为:薄膜电阻、薄膜电容、薄膜衰减器、陶瓷垫块、陶瓷短路片、个性化薄膜电路等。
The major products are film resistors, film capacitors, film attenuators, ceramic blocks, ceramic short-circuit plates, individualized film circuits, etc.
传统的检测方法是让触点接通一个较大的电流,以消除薄膜电阻,此时触点的接触电阻即为收缩电阻。
The traditional measuring method is that passing a large current through contacts so that velamen resistance is eliminated, then contact resistance is nothing but contraction resistance.
该传感器经过激光微调,以实现高精度量程、偏移校准和温度补偿,并在每个芯片上集成了应变片和薄膜电阻网络。
The sensor is laser trimmed for precise span, offset calibration and temperature compensation. Also includes a strain gauge and thin film resistor network integrated on each chip.
晶圆级,激光微调,薄膜电阻和温度,真实姿态补偿NMOS管开关保证在整个工作温度和特殊林耳和经营范围的增益稳定性。
Wafer-level, laser-trimmed, thin-film resistors and temperature-compensated NMOS switches assure operation over the full operating temperature range with exceptional lin- ear and gain stability.
利用短脉冲激光加热浸没在水丙酮非共沸工质中的铂薄膜电阻的方法,对不同体积配比的工质在超急速温升条件下的沸腾进行研究。
The platinum film resistor that is immerged in water-acetone mixture is heated by short pulsed-laser to investigate the mixture's boiling behavior under rapid temperature rise condition.
提出了一种薄膜电阻加载的矩形螺旋型谐振器,并利用其设计了一种甚小尺寸的微带均衡器子结构电路,对薄膜电阻的加载位置也进行了研究。
A miniaturized microstrip planar equalizer substructure incorporating this thin-film resistor loaded spiral resonator is designed and simulated and the loading position is also studied.
利用X射线衍射和能量散射X射线能谱表征方法,并结合薄膜方块电阻的测定,探讨了热处理方式和热处理温度对薄膜化学组成及薄膜电阻的影响。
Then, the effects of heat treatment and temperature on the chemical composition and sheet resistance of the prepared films were investigated by XRD, EDXS and sheet resistance measurements.
因为电子可以在此石墨薄膜里穿行就像几乎没有重量,所以电阻极低,可以传递更快的电流。
As graphene allows electrons to travel through it as though they were weightless, it promises faster electronics.
在氧化铅薄膜三层结构的电流——电压特性中发现了具有负电阻区的开关现象。
Switching phenomena with an associated negative resistance region have been observed in the current-voltage characteristics of lead oxide film sandwiches.
这类应用可能包括电容器的漏电流、二极管反向漏电、电缆或薄膜的绝缘电阻等。
Some of these applications may include leakage current of capacitors, reverse diode leakage, or insulation resistance of cables or films.
本项研究目的是制作微型高精度铂薄膜热敏电阻器与集成电路配合,用于工业和科研中温度的精确测量。
The micro Pt-film thermal resistors of high precision are developed to match the ICs for precise temperature measurement in industry and scientific research.
在玻璃衬底上改变实验条件沉积了不同颜色的薄膜,测量了不同色泽薄膜的电阻率和制备条件的关系。
The films of different color were deposited on the glass substrates with different experimental conditions, the resistivity of different color films was measured.
设计了一种铂薄膜热电阻温度探针。
A platinum film resistance temperature probe has been designed.
针对手提式薄膜方块电阻测试仪在使用中容易出现的问题,进行分析研究,提出了解决方案,并在实验中得到实现。
Analyzing the problems which often happen in the portable square resistance meter for the thin films on ITO glass surface, some solutions were proposed and carried out by tests.
用扫描电子显微镜观察所得金刚石膜的表面形貌,用ZC 36高阻仪测量金刚石薄膜的电阻率。
The surface morphology of the diamond films were observed with SEM, and the resistivity of diamond films were measured with ZC36 high resistance instrument.
本文报导一种测量高温超导薄膜微波表面电阻的新方法和测试装置。
A new method and experimental device for measuring microwave surface resistance of high Tc superconducting thin films are presented in this paper.
本论文主要研究对象是两种类型的磁电阻薄膜材料:锰基钙钛矿结构氧化物三明治多层膜和金属颗粒膜。
In this dissertation, we investigate mainly two types of film materials with magnetoresistance effects: the manganese perovskites oxide sandwich films and metal granular films.
本文介绍了两种测试高温超导薄膜微波表面电阻的方法:双谐振器法和蓝宝石介质谐振器法。
Two kinds of microwave surface resistance Rs measurements of high Tc superconductive thin films are introduced in this paper, two-resonator method and the sapphire resonator method.
本文介绍了两种测试高温超导薄膜微波表面电阻的方法:双谐振器法和蓝宝石介质谐振器法。
Two kinds of microwave surface resistance Rs measurements of high Tc superconductive thin films are introduced in this paper, two-resonator method and the sapphire resonator method.
应用推荐