实验在一自制的脱硫塔中进行。
沼气发电系统主要由脱硫塔、沼气柜、发电机组等组成。
The biogas generating system is composed of desulfurization tower, biogas tank, generator, etc.
有实际的项目设计经验， 特别是有火电厂脱硫塔设计经验尤佳。
More than 3 years solid experience for project design, prefer to have FGD tower design experience.
对烟气循环流化床脱硫工艺和脱硫塔设计进行详细的介绍，为设计提供参考。
The desulfurization process and absorber design of flue gas circulating fluidized bed were described in detail to supply reference for design.
本文针对湿法脱硫中不锈钢脱硫塔的防腐失效原因进行了分析，并采取了相应的防腐措施。
This paper analyzed the reasons of the invalidation of the corrosion protection measurements in the stainless steel desulfurizer, and relevant anti-corrosion measurements were introduced.
系统运行情况表明，在选择适当的雾化喷嘴后，脱硫塔还可以起到对细粉尘的二次净化作用。
The operation result indicates that if appropriate spray nozzle is selected, the spray tower can also separate fine dust particles from the gas stream.
现阶段电厂脱硫塔搅拌装置均为侧进式搅拌器，受工况条件限制，侧进式搅拌设备具有许多缺点。
At this stage mixing devices in desulphurization plant are side entering agitator, limited by the working conditions the side into mixing devices has some shortcomings.
针对催化剂装填更换中存在的问题，介绍对脱硫塔的改造情况，以及日常操作、检修中的一些预防措施。
For the catalyst replacement problems, introduce the desulfurizer modification, and some preventive measures in operation and maintenance.
厌氧产生的沼气经过脱硫塔除去沼气中的H2S，进入沼气柜后经脱水器去除沼气中的液体水，然后进入沼气发电机发电。
The anaerobic produced biogas is removed the H2S through desulfurization tower, wiped off water by dewatering device in biogas tank, and then enters into the generator.
脱硫吸收塔结构及荷载形式复杂，常规设计计算方法不能给出其应力和变形分布情况。
The structure and load form of the absorbing tower is complex and regular design and calculation method cannot give its distribution condition of the stress and deformation.
介绍了鼓泡塔湿法脱硫的基本原理以及工艺过程，其工艺核心为鼓泡式反应器。
This article briefs the basic principle and technological process of wet method FGD and emphatically introduces its technological core-jet bubbling reactor(JBR).
建立逆向气液喷淋反应塔，利用焦化废水进行烧结烟气脱硫试验研究。
A spray tower was built, and experiment was carried out on desulfurization of sintering flue gas with coking wastewater.
介绍了气体脱硫再生塔底重沸器腐蚀状况、探讨了腐蚀的原因和防腐蚀措施。
The corrosion of bottom reboiler of regeneration tower of gas desulfurization unit was introduced. The causes corrosion of and protection measures were studied.
进行了生物膜填料塔挂膜启动及烟气脱硫实验研究。
The experiments on the start-up of the biotrickling filter and the desulfurization of flue gas were conducted.
通过对南京工程学院湿法烟气脱硫系统喷淋塔的数值模拟，分析了液体分布环(ldr)对塔内烟气流场的影响。
The influence of liquid distributed ring (LDR) on flow field in spray scrubber of Nanjing Institute of Technology project has been analyzed by means of numerical simulation.
利用实验室建立的旋流板塔脱硫除尘中试系统开展了各种结构参数对系统阻力损失的影响研究，为系统的放大设计提供了实验依据。
The influence of various construction parameters on system resistance is studied in a model swirl board scrubber. It can be served as a fundation for a prototype scale design.
采用喷淋空塔对海水及海水淡化浓盐水的脱硫效率进行了研究。
The desulfurization efficiency of seawater and desalinating byproduct brine were studied by using a spray empty absorption tower.
本文介绍了旋转喷雾干法烟气脱硫中试装置的试验情况，对吸收塔的运行条件进行了研究。
The experimental circumstances of the title research in a pilot plant scale are presented, and the performing conditions of the absorption tower have been studied.
通过增加浓缩副塔，解决原浓缩塔脱硫能力不足的问题。
The shortage of sulfide com - pounds removing capacity is solved by adding a vice-concentration tower.
反应塔脱硫效率超过95%，系统脱硫效率超过70%，系统除尘效率大于94%。
DeSOx efficiency of the reaction tower exceeds 95%, while the system DeSOx efficiency exceeds 70%. Dedust efficiency is more than 94%.
详细介绍国内某电厂的脱硫-烟塔合一工程设计，特别是烟塔的设计。
The engineering design of desulfurizing and NDCT with flue gas injection, especially the tower design, in a domestic power plant is introduced.
目前，在煤气脱硫工艺中普遍采用木格填料塔脱硫。
At present, a general practice in the desulfurization of city gas is to use desulfur columns filled with wooden lattice packing.
喷淋塔是湿法脱硫系统的核心设备，它的优化设计时于提高脱硫效率至关重要。
Wet flue gas desulfurization (WFGD) is a widely used process for flue gas desulfurization technique and a spray scrubber is a key device in WFGD system.
生化法烟气脱硫，要求吸收反应塔湍动程度高，气液接触好，反应速度快。
It's very important for Turbulent Bed Contactor to turbulate seriously, have good contaction between gas and liquid and react quickly in the biochemistry desulfuration technology.
为提高湿法烟气脱硫液柱冲击塔的脱硫效率，研究了塔内流场分布情况及其对SO2。吸收的影响。
To improve the SO2 removal efficiency of impinge stream scrubber for wet flue gas desulfurization, the flow field distribution in the scrubber and its effects on SO2 absorption were studied.
为进行烧结烟气的脱硫处理，建立了密相干塔烟气脱硫新技术的试验装置，并进行了脱硫试验研究。
For desulphurization of sintering gas, a pilot dense flow absorber was built and desulphurization experiment was carried out.
电除尘器的入口置有与电除尘器组成一体的惯性分离器，惯性分离器的进风口与脱硫反应塔的上部连接；
The air inlet of the inertia separator is connected with the upper part of the desulfurizing reaction tower. The lower port of the inertia separator is directly connected with the middle ash can.
设计了一种新型的液柱冲击塔脱硫装置，通过冷态试验研究各种结构和运行参数的变化对液柱冲击塔脱硫效率的影响。
The effects of different geometry and operation parameters on the desulphurization efficiency in the scrubbers were studied on an experimental platform.
设计了一种新型的液柱冲击塔脱硫装置，通过冷态试验研究各种结构和运行参数的变化对液柱冲击塔脱硫效率的影响。
The effects of different geometry and operation parameters on the desulphurization efficiency in the scrubbers were studied on an experimental platform.
应用推荐