结果表明，不同结晶形态的PP其性能差别很大。
The results show that properties of PP change with its crystalline state.
对粤蛇葡萄黄酮化合物的纯化方法及结晶形态进行了研究。
The purification method and crystallization shape of ampelopsis flavones were studied.
对复合材料进行热性能、结晶形态及微观形态测试分析。
The thermal behavior, crystalline morphology and micromorphology of the composite were tested and analyzed .
PEG - DE引起了膜内的丝胶蛋白结晶形态的变化。
PEG-DE caused the condensed structure of sericin films to change.
壳聚糖浓度不同结晶形态发生变化，浓度过高会抑制晶体成核生长。
The morphology of minerals would be changed by different concentration of chitosan in the system, but nucleation and crystallization could be inhibited in higher concentration of chitosan.
利用SEM、XRD等测试手段研究了品质不好的石灰石的结晶形态。
The crystal forms of limestone have examined by SEM, XRD and other test means.
结果表明：随着热处理温度的不同，模塑粉的结晶形态也相应发生变化。
The results showed that the state of polyimide moulding powder changed with heat treating temperature.
有效的结晶增长、结晶形态与缩聚反应的解耦合是强化固相缩聚技术的科学基础。
Enough research of crystallization and crystalline form is the base to improve the technology of ssp process.
研究了石灰活性对烧结矿中铁酸钙的结晶形态、烧结矿品位、强度和成品率等的影响。
The influences of the lime's activities on the form of calcium ferrite, the sinter's grade, intensity and yield have been studied in this paper.
用小角光散射、电子显微镜等方法研究了熔体温度对熔融结晶的PTFE结晶形态的影响。
The influence of the melt temperature on the crystalline morphology of polytetrafluoroethylene was studied by Small Angle Light Scattering and Electron Microscope techniques.
采用偏光显微镜和光学解偏结晶速率仪研究了嵌段聚醚酯共聚物的结晶形态和等温结晶过程。
The crystallization morphology and isothermal crystallization process were studied by means of polarized microscope and DLI (Depolarized Light Intensity) for poly (ether ester) block copolymers.
利用偏光显微镜观察了聚丙烯共聚物(CPP)在透明成核剂TM - 3作用下的等温结晶形态。
The isothermal crystallization morphology of polypropylene copolymer (CPP) containing TM-3, a clarifying nucleator, was observed by polarized light microscope.
在反应过程中，P沸石首先呈短柱状结晶，随着反应时间延长，结晶形态发生变化，由短柱状向菱面体过渡。
In reaction process P-zeolite first appears the short column crystal and then the crystal pattern changes from short column to rhombohedron with reaction time lasting.
在定长状态下纤维的熔融吸热峰会发生很大变化，若在适当温度下进行热处理，可加速结晶形态的转化过程。
The melting peaks changed largely under fixed length state. Annialing fibers at a suitable temperature can accelerate the transition between the crystal morphologies.
偏光显微镜结果表明，HSPS的加入对共混物中PA1010的结晶形态有明显影响，使PA1010球晶细化且不完善。
It was observed from the POM that HSPS had great effect on the crystalline form of PA1010 in the blends, causing the spherulite of PA1010 smaller and less perfect.
摩擦系数由不含成核剂时的0.19894降低到了0.18121；SEM表明其结晶形态为摺叠扭曲形波浪起伏结构。
The frictional coefficient decreased from 0.19894 to 0.18121. SEM indicated that the crystal morphology was changed by REC.
该结晶形态的普瑞巴林，与非结晶形态和其他结晶形态的普瑞巴林相比，具有稳定性好、适合大规模生产、产品质量可控等优点。
The crystalline pregabalin has many advantages. For example, its stability is good, it is suitable for mass production, its quality can be controlled and so on.
采用偏光显微镜(PLM)、差示扫描量热仪(dsc)、毛细管流变仪和拉伸试验机对透明聚丙烯(PP)的结晶形态、热学、流变性、力学性能进行了研究。
In this paper, the crystalline morphology, thermology, rheology and mechanical properties of clarified PP are investigated by PLM, DSC, Rheometer and stretch tester.
研究了熔融温度、熔融时间、冷却方式及结晶温度对尼龙66球晶形态和大小的影响。
The influence of melting temperature, melting time, crystallization temperature and cooling mode on form and size of nylon 66 was studied.
POM表明，共混物中的PHB球晶形态产生显著变化，球晶尺度减小，且二次结晶被抑制。
It was discovered by POM that spherulitic morphology of PHB in the blend changed significantly, size of the spherulites decreased and the secondary crystallization of PHB was inhibited also.
含蜡原油粘弹性源于其内部的蜡结晶量与复杂的蜡晶形态及结构，但二者间的定量关系仍未建立起来。
The viscoelasticity of waxy crude oil originates from its internal wax crystal amount and its complex wax crystal shape and structure, but the quantitative correlation between them is not established.
在正交偏光显微镜（PLM）和扫描电镜（SEM）下观察了不同结晶条件下PA1010/6共聚物结晶及球晶形态。
The spherulite morphology of PA1010/6 crystallizing at different conditions was studied by PLM and SEM.
在正交偏光显微镜（PLM）和扫描电镜（SEM）下观察了不同结晶条件下PA1010/6共聚物结晶及球晶形态。
The spherulite morphology of PA1010/6 crystallizing at different conditions was studied by PLM and SEM.
应用推荐