钢液弯月面处的磁感应强度是结晶器中心最大值的10%左右。
The magnetic induction intensity at meniscus was about 10% of that maximum value at mould middle section.
结晶器铜管在引仲加工过程中，由于凹模中心线与机床运动方向轨迹线不同，造成加工干涉和产品缺陷。
In the course of drawing process, the process interference and defect take place because of the difference between the centerline of concave die and the trace of moving direction.
该反应结晶器由上大下小的圆筒、中心加料筒、轴流泵和循环管组成。
The crystallizer consists of a cylinder which is of big top and small bottom, a focus charging cylinder, an axial flow pump and a circulating tube.
感应线圈的最佳安装位置位于结晶器切缝区域中心；
The optimal installation site of the induction coil is located in the center of slit zone in the mold.
感应线圈的最佳安装位置位于结晶器切缝区域中心；
The optimal installation site of the induction coil is located in the center of slit zone in the mold.
应用推荐