出风筒对准干式变压器各相线圈和铁芯。
The chimney fans aim at coils and iron cores of the air-immersed transformer.
指出，采用双电容移相线路可增大电机力矩。
It pointed out that motor torque may be increased by double electric capacity phase-shift circuit.
在转子的转动的同时获取在每相线圈的反电动势。
As the rotor moves, the back-EMF is acquired in each phase of the coil.
计算表明，断口表面层绝热升温温度依然高于液相线温度。
The adiabatic heating induces the temperature of fracture surface layer to be higher than the liquidus temperature too.
光纤复合相线(OPPC)是将光纤单元复合在相线中的光缆。
Optical fiber composition phase conductor (OPPC) is an optical cable with optical fiber unit in phase conductor.
结果表明：锰降低液相线温度和共晶温度，缩小凝固温度范围；
The results show that: manganese lowers liquidus and eutectic temperature, and narrows down the temperature range of solidification;
确定了岩石固相线与液相线的温度，岩石结晶程度与温度的关系。
Solidus and liquidus temperatures of the rocks and relationship between crystallinity and crystallization temperature have been determined.
它们与钢的固相线和液相线温度的高低及结晶温度区间的大小有关。
With the steel line and the solid phase of the high and low liquidus temperature and crystallization temperature of the size of interval.
采用梯形模糊数估计配变负荷变化情况，建立了单相线路网络模型。
A trapezoid fuzzy figure is adopted to estimate the load change of distribution transformer and the single-phase distribution network model is constructed.
低液相线温度允许低电解温度，而降低电解温度可大大提高电流效率。
Low liquidus temperature enables low bath temperature. The current efficiency increases with the decreasing of bath temperature.
采用近液相线半连续铸造的方法制备了ZL201铝合金半固态锭坯。
The near-liquidus semi-continuous casting (LSC) process was used in casting ZL201 alloy.
对ZL 111铝合金在近液相线的温度保温后的铸态组织进行了研究。
The microstructure evolution of ZL111 by heat holding above the liquidus temperatures was investigated.
移相线路中配有与弦移相器以满足可控硅整流器最大可能触发电流和电压。
A cosine phase shifter is applied in phase shifting circuit to meet the possible maximum trigger current and voltage of thruster.
阐述了电气回路中谐波电流产生的原因及其引起中性线和相线过载的危险。
The paper presents the causes of harmonics current and overload hazard of neutral line and phase line by harmonics in electrical line.
在液相线附近，晶粒尺寸随着浇铸温度的降低而逐渐减小并呈球化的趋势。
In the liquidus nearby, the grains size becomes coarse with increasing of casting temperature.
所述相线分线排、零线分线排、地线分线排与所述基板或基盒活 动连接；
The phase line branching bank, the zero line branching bank and the ground line branchingbank are movably connected with the base plate or the base box.
四相线路可以采用两相邻相运行，能提高输电系统运行的可靠性与暂态稳定性。
The reliability and transient stability of the transmission system may be improved, because two adjacent phase conductors of four-phase transmission lines can be operable.
当配线采用多相导线时，其相线的颜色应便于区分，相线与零线的颜色应不同。
When the wires are multiphase conductor, it should be easy for us to distinguish the colors, and the color of phase should be different from that of the zero line.
选用正交试验法，研究了A356铝合金近液相线半连续铸造工艺参数的影响。
Studying the nearby liquidus semi -continuous casting technics of A356alloy by means of orthogonal test.
提出了一种采用电磁传感器为高压巡线机器人沿输电线路相线进行导航的方法。
A method of electromagnetic sensor navigation of inspection robot for high-voltage transmission line is proposed.
在合金熔炼和加工过程中，往往需要知道液相线温度，以便确定相关工艺参数。
During the melting and processing practices, an accurate knowledge of liquidus temperature is necessary in the determination of process parameters relating to a given alloy.
用多尺度模拟方法研究了近液相线半连续铸造中的ZL201合金的液/固相变。
The solid/liquid phase transformation of ZL201 aluminium alloy in near liquidus semi-continuous casting was simulated using multiscale simulation technique.
即使在三相正弦激励的作用下，三相线电流也将发生非正弦畸变，产生谐波电流。
Even if it worked with three-phase sine, three-phase line current would have non-sine aberrance and produce harmonic wave-electricity.
接地触头。然后，电磁脉冲感应到的扩展插座的其他电线，例如。 相线和中线。
The electromagnetic pulse is then induced into the other wires of the extension socket, eg. the line and neutral.
采用稳态极化技术研究了三相线长度、宽度及溶液浓度在金属腐蚀阴极过程中的作用。
The effect of the TPB zone on the cathodic process of metals was studied by steady-state polarization test.
研究了近液相线半连续铸造ZL201合金的微观组织及其在二次加热过程中的变化。
The casting and remelted microstructures of ZL201 alloy cast by liquidus semi-continuous casting(LSC)were studied.
研究了液相线铸造A35 6铝合金在不同保温温度、不同保温时间下的组织形成规律。
The engendering rule of organism of liquidus casting aluminum alloy A356 at different heat preservation temperature, different heat preservation time was investigated.
在合金两个不同等深面上，界面移动速度增加时，固相线和液相线向同素异型相界T0曲线靠近；
The kinetic solidus and liquidus approach to T0 curve with increasing growth velocity on two different isopleths of the alloys.
所以线路换位的目的是要使每相导线感应阻抗和每相的电容相等，以减少三相线路参数的不平衡。
It analyzed the unbalance of both single-circuit line and double-circuit lines in same tower, made a summary of their transposition methods.
所以线路换位的目的是要使每相导线感应阻抗和每相的电容相等，以减少三相线路参数的不平衡。
It analyzed the unbalance of both single-circuit line and double-circuit lines in same tower, made a summary of their transposition methods.
应用推荐