最大限度地减少相对昂贵的组件(如微控制器、接口控制器、电流隔离器和晶体)可以显著降低系统的总体成本。
Minimizing the number of relatively costly components, such as microcontrollers, interface controllers, galvanic isolators, and crystals, can significantly reduce total system cost.
涡电流隔离器自从20世纪90年代早期就开始得到使用,它是由长瓶状转鼓内的一个快速旋转磁力转子组成的,转鼓的旋转速度会较慢。
Eddy-current separators, in use since the early 1990s, consist of a rapidly revolving magnetic rotor inside a long, cylindrical drum that rotates at a slower speed.
连接的电气元件有断路器、隔离开关与接地开关、电流互感器、电压互感器、避雷器、母线等。
The electrical elements connected include circuit breaker disconnector and earthing switch current transformer voltage transformer lightning arrester bus etc.
介绍了现有常用高压隔离驱动电源的类型及其优缺点,重点介绍基于电流型交流母线的高压隔离驱动电源。
The normal type of drive power supply with multiple isolated outputs including the dominance and weakness are introduced, focusing on the type based on current AC-bus.
采用电磁隔离霍尔元件进行电流检测,采用了IGBTCPV 363m 4 K模块组成逆变桥来实现功率主回路直流到交流的逆变。
Electromagnetism isolated Hall sensor is used to sense the phase current of the PMSM, and the IGBT CPV363M4K module is used to implement the inverter.
本文以VDNAP为基础实现了配网潮流及短路电流计算、配网故障隔离模拟及配网重构。
This article realizes the short circuit current calculation, power flow calculation, fault isolation's simulation and reconfiguration of the distribution network based on the VDNAP.
仪器采用独特的高速磁隔离数字传感器直接采集输入的电压、电流信号,保证了数据的可靠性和安全性。
Using a unique high-speed magnetic isolation digital sensor to directly collect the signal of input voltage and current, ensure the data reliability and security.
仪器采用独特的高速磁隔离数字传感器直接采集输入的电压、电流信号,保证了数据的可靠性和安全性。
It USES a unique high-speed magnetic isolation digital sensor to directly collect the signal of input voltage and current, ensure the data reliability and security.
对于隔离的LDMOS器件,横向隔离壁(32)(结合至源极)与埋层(24)之间的电阻减少,从而减少了衬底注入电流。
For isolated LDMOS devices, the resistance between the lateral isolation wall (32) (tied to the source) and the buried layer (24) is reduced, thereby reducing substrate injection current.
灯具泄漏电流测试线路中隔离测试变压器次级接地问题直接影响着测试结果的准确性。
The earthing of secondary circuit of an isolating test transformer on the circuit for luminaire leakage current test strongly influences the accuracy of test results.
电流传感器隔离测量方法中测量电路完全与点火电路隔离,提高了测量的准确性,增强了点火试验的可靠性。
The measuring circuit of the current sensor isolated measuring method is completely isolated from firing circuit, thus the measuring accuracy and test reliability can be improved.
隔离电流-橡皮圈在低电流瓦数下做绝缘体,因此可在暴露电线芯的地方缠上橡皮筋(在不通电的情况下)。
Insulate electrical current - rubber bands can act as insulators for low wattage electrical current. Wrap a rubber band around an exposed region of a wire (before the wire is live).
后者采用能防止浪涌电流或过载电流从安全区传输到危险场所的高度可靠的隔离措施来保证安全。
The latter can be used to prevent the surge current or overload currents from the security zone transmission to the dangerous place to ensure the reliable isolation security.
针对电流小信号采集中存在噪声干扰的问题,采用高线性度模拟光耦hcnr 201设计了电流信号隔离采集板。
Aiming at the noise jamming problems in acquisition of small current signals, an isolation and acquisition board for current signal is designed based on HCNR201 high-linearity analog optical coupler.
论述船用跟踪雷达角伺服系统在不同驱动方式下对船摇扰动隔离效果最好的方法,并对扰动模式进行了分析,指出在陀螺回路内加电流环路可进一步提高船摇隔离度。
Based on the analysis of the different interference patterns, a method in which a current loop is added in gyro loop to further improve the degree of isolating for the ship rocked is presented.
在信号传感器或信号转换器遇到接地的输入或输出信号时,电流环路信号隔离器减少现场测量难题。
DEVAR current loop signal isolators reduce problems found in field measurements when signal transmitters or converters encounter both input and output signals that may be grounded.
因此如何准确可靠地检测并隔离故障线路,寻找精度高的接地保护方法一直是小电流接地系统的一个重要研究课题。
The problem of how to detect and isolate fault feeder correctly and reliably, and look for a protection method with high precision is always an important research task.
论文通过对全波整流输出电路与其他副边整流电路的比较,得出采用全波整流电路特别适合隔离型低压、大电流输出的DC/DC变换器的结论。
Compared to the other second-side rectifier, it is concluded that the full-wave Rectifier is well adapted to the Low-voltage High-current DC-DC converter.
针对目前电气隔离器件状况,提出基于高精度线性光耦hcnr201的电压、电流测量电路。
Introduced are measuring circuits of voltage and current based on HCNR201, high-precision and high-linearity optocoupler, after surveying different kinds of current electrical isolators.
采用平面选择注入隔离工艺制作MESFET及旁栅电极,通过改变半导体特性测试仪的延迟时间参数,深入研究了不同沟道电流的数据采集时间对旁栅效应迟滞现象的影响。
The influence of different data collection time of channel current on the side gating hysteresis effect is studied by changing the delay time of semiconductor characteristic testing set.
通过双限流电路和浪涌强制吸收或隔离保护电路的设计,解决了大功率半导体激光器驱动电源常见的浪涌冲击和电流恒定的难题。
The double limit current circuit and electronic surge force absorbed or isolated circuit are introduced. The problems of electronic surge strike and current stable are solved.
本文分析了DC/DC变换器一些基本拓扑的结构及其特点,对隔离式DC/DC变换器原边和副边拓扑进行了分析和比较,得出了隔离式低压大电流输出DC/DC变换器的优选拓扑结构。
Secondly, this dissertation educes the promising topologies for isolated low-voltage high-current output DC/DC converters by analyzing and comparing the basic topologies of the DC/DC converters.
腐蚀后的上隔离沟槽边缘平整,其深度和宽度可以解决注入电流在相邻像素之间产生的干扰问题。
The edges of the grooves after etching are plane and smooth. The depth and width of the grooves can solve the interference problem induced by the injection current between the adjacent pixels.
腐蚀后的上隔离沟槽边缘平整,其深度和宽度可以解决注入电流在相邻像素之间产生的干扰问题。
The edges of the grooves after etching are plane and smooth. The depth and width of the grooves can solve the interference problem induced by the injection current between the adjacent pixels.
应用推荐