一个相当基础的电路(留作练习，不过并不难)处理控制电压并输出与电压成比例的恒流。
A fairly basic circuit (left as an exercise, but it's not difficult) can take the control voltage and output a constant current which is proportional to the voltage.
具有电压调节范围宽，电路简单，输出稳定，可靠性强，人机交互接口优良，应用范围广泛等特点。
And it has the features of wide range regulation of voltage, simple circuit, output stability, reliability, excellent interactive interface, being widely used and so on.
通过简单分析该主电路的结构形式和工作原理，证明它是一种对电网污染少、整流输出电压特性好的焊接电源主电路形式。
By analyzing its structure and working principle, it proves that the new circuit has little pollution to the network and has well characteristic of the output voltage.
这种将传感器输出转换成电压信号，并与系统的其它电路相连接的过程，称为信号调理。
This process of converting the transducer output into a voltage signal which can be connected to the rest of the system is called signal conditioning.
将静电计置于电压模式，然后打开外部反馈，就把反馈电路从内部网络切换到连在前置放大器输出端的外部反馈网络上。
Placing the electrometer in the volts mode and then enabling external feedback switches the feedback circuit from an internal network to a feedback circuit connected to the preamp output.
PT100温度传感器和精密电阻构成的电桥测量电路输出微弱的电压信号。
The electrobridge measurement circuit, which consists of PT100 temperature sensor and precise resistance, outputs slight voltage signals.
分析了所用的PWM驱动电路的输出电压和电流波形，并给出实际应用电路以及实验结果。
Analyzes the waveform of output voltage and current of PWM drive circuit, and also gives practical application circuits and test results.
这两种电路都具有功率因数高、输出电压较低等特点。
Two circuits, characterized by high Power Factor and low output voltage, are proposed.
利用集成运算放大器的特点，设计了输出电压无非线性误差的电桥电路传感器。
Using the characteristic of integrated operational amplifier, an electric bridge circuit sensor without nonlinear error in its output voltage is designed.
在直流稳压电路里，采用了可调的集成稳压器，使输出电压可以调节。
In the circuit, the adjustable integrated regulator has been adopted, which can adjust output voltage.
分析了用运算放大器组成正弦波振荡电路的起振条件和输出电压幅值的调节及选频网络的构成。
This paper is involved in the analysis of oscillation starting condition, output voltage amplitude adjustment, and frequency selection network composition of sinusoidal coave oscillation circuit.
然后，在这一结论的基础上对原先的实验电路进行了结构的优化，使用软开关技术与谐振技术使输出电压、电流满足电源系统的基本要求。
Then we improve the circuit of the experiment based on the conclusion, make the current and voltage better using of the technology of soft switching and series resonance.
利用发射线圈与电容并联的谐振调幅电路，将线圈阻抗变化转换成电压的输出。
The emitting coil and capacitance are connected in parallel and form a resonant amplitude-modulation circuit, which converts the impedance into output voltage.
这个传感器的电路模拟输出电压发送到3迟滞比较器。
For this the analog output voltage of the sensor circuit is sent to 3 comparators with hysteresis.
测量电路可直接输出与电容值相对应的电压值；
The voltage value related to its capacitance value can be output directly by the measurement circuit.
第三部分逆变电路，输出所需交流电压；
The third part introduces inverter circuit, it provides two needed sine output voltage.
经PSPICE软件仿真和小功率电路实验证明，“通过改变开关角而实现调节输出电压”的闭环设计方案是可行的。
Tested by PSPICE simulation and small power experiment, the designing project "adjusting output voltage by changing on and off time of the SPWM" is practical.
本发明提供一种用于确定输出到比较器的输入电压值的方法及光驱动电路。
The invention provides a method of performing input voltage value to comparator and an optical-driving circuit.
由于直流供电电源纹波的影响，电压控制SPWM逆变电路的输出谐波分量幅值较大。
Because of the ripple of the DC power supply, the output harmonic amplitude of the voltage controlled SPWM inverter is higher.
该器件不仅输出电流可调范围宽、允许工作电压变化范围大、电路接口与TTL兼容，而且体积小、调节方便。
The device has several advantages such as adjustable wide current range, controllable wide voltage range, circuit interface compatible with TTL, small volume and easy modulation.
分析了一般电桥电路作为传感器其输出电压产生非线性误差的原因。
The reason of nonlinear error caused by output voltage in common electric bridge as the sensor is analyzed.
根据高频机箱中受控对象的使用要求，采用AT 89 C52为核心电路，设计了多路电压量输出控制器。
According to usage request of controlled objects in high frequency box, adopt AT89C52 for the core electric circuit, designed multiplex voltage output controller.
在电子技术中，把交流电转换成低电压直流电的一种电路。这种电路的输出是经过调整的，使它的噪声及电压波动都很。
In electronics, a circuit for converting AC voltage to low voltage DC in such a way that the output is regulated to minimize noise and voltage fluctuation.
本发明电路结构简单，输出的交流电的波形为纯正弦波，输出的电压和频率稳定，不会随输入电压和负载的变化而变化。
The circuit of the invention is simple, the wave output is pure sine wave, voltage and frequency output is stable, they do not change with input voltage and load.
在传统的CMOS电荷泵电路中，电荷泵输出的电压受MOS管的阈值电压限制，所以当要求电荷泵的输出电压较高时，则不得不连很多阶来达到要求。
In conventional CMOS charge pump circuits, the pumping high voltage is limited by MOS threshold voltage, so that it can not use less cascade stages to pull up a high voltage which we want to generate.
根据KA3525的应用特点，设计了一种基于该电流型PWM控制芯片和单片机控制实现输出电压可调的稳压电源电路。
According to the applied characteristics of the KA3525, a regulated power supply circuit based on a PWM controlled chip and controlled by single-chip processor was designed.
文中还介绍了IGBT栅极驱动电路和IGBT电压均衡电路的设计方法，并给出调制器的输出波形。
The design of the grid-driven circuit and the voltage balancing circuit for IGBT are also introduced, giving the output wave of the modulator.
解决上述问题的方法是自动控制输出电路MOS管的栅极电压变化率。
This problem can be solved by controlling the variety speed of the G-S(grid-source) voltage of MOS transistors.
解决上述问题的方法是自动控制输出电路MOS管的栅极电压变化率。
This problem can be solved by controlling the variety speed of the G-S(grid-source) voltage of MOS transistors.
应用推荐