材料的腐蚀过程为电化学腐蚀控制。
The corrosion process of materials was electrochemical control.
介绍了金属腐蚀的类型及电化学腐蚀。
The kinds of metal corrosive and electrochemistry corrosion are introduced.
避免因电位差而引起彩板的电化学腐蚀。
Avoiding electrochemistry erosion of colourful plank caused by electrical potential difference.
对铁在碱性溶液中的电化学腐蚀过程进行了讨论。
The electrochemical corrosion process of iron in concentrated alkaline solution was discussed.
采用电化学腐蚀法对6种牙科合金进行了实验研究。
The electrochemical corrosion method was taken to study 6 kinds of dental alloys.
论述了金属的电化学腐蚀和外加电流阴极保护原理。
Electrochemical corrosion of metal and principle of the applied current cathodic protection are expounded.
但在海洋环境下，钢结构电化学腐蚀的问题非常突出。
But in the Marine environment, the problem of electrochemical corrosion of steel structures is very prominent.
第三章研究了用脉冲电化学腐蚀制备均匀发光多孔硅。
In the third chapter Porous silicon was prepared by pulsed and dc electrochemical etching methods under the equivalent etching condition.
提高磷酸酯抗燃油的电阻率，避免元件发生电化学腐蚀。
Promote the resistance of fire resistant oil, to protect elements against electrochemical corrosion.
电化学腐蚀测试表明经氮化处理后合金的耐腐蚀能力大为提高。
Electrochemical corrosion test show that corrosion resistance increase greatly for the nitriding treated alloy compared with substrate.
研究了注碳外延硅经氢气退火及电化学腐蚀处理后的荧光特性。
Photoluminescence properties of epitaxial silicon implanted carbon after annealed in hydrogen and anodization are measured.
结果表明：叶轮的腐蚀失效是电化学腐蚀和冲蚀交互作用的结果。
The analysis showed that the blade corrosion failure was the result of the interactions of electrochemical corrosion and erosion.
采用CS300P型电化学腐蚀工作站检测了梯度涂层的耐蚀性能。
The corrosion resistance of the gradated coating was tested using CS300P electrochemical corrosion workshop.
方法：电化学腐蚀法测试镍铬合金用有机金浆涂覆前后的腐蚀行为。
Methods: The corrosive resistance of ni - Cr alloy was tested by electrochemical method before and after coated with organic gold paste.
发现，柯伐镀金盖板遭致电化学腐蚀是导致气密性失效的主要原因。
It is found that couple corrosion of the package lid is responsible for the failure.
脉冲镍镀层具有较佳的电化学腐蚀特性和对铀基体更好的防腐蚀性能。
The electrochemical corrosion characteristics and resistant performance of pulse plated nickel deposit for uranium substrate is better than DC deposit.
另一方面也改变了金属腐蚀的电极电位，从而避免或降低了电化学腐蚀。
On the other hand also changes the electrode potential of metal corrosion, so as to avoid or reduce the electrochemical corrosion.
碳纤维部件可能会包含少量的玻璃纤维或芳纶纤维用作绝缘层或电化学腐蚀保护。
Carbonfiber parts may include small quantities of Glassfiber or Aramidfiber used as dielectric coating or galvanic corrosion protection.
本文基于电化学腐蚀原理，制备微细电化学线切割加工中使用的微米尺度线电极。
Based on electrochemical etching principles, the paper fabricated the micrometer scale wire electrodes used in WEMM.
通过电化学腐蚀测试测出阳极极化曲线，分析了在不同环境和溶液中的耐腐蚀性能。
Anode polarization curves were measured by electrochemistry corrosion and resisting causticity was analyzed in different condition and solution.
卓越的耐腐蚀性能：除少数强氧化剂外，可耐多种化学介质的侵蚀；无电化学腐蚀。
Excellent corrosion Resistant Performance: except for few of strong oxidant, may endure the corrosion of various chemical mediators; no electrochemical corrosion.
从电化学腐蚀原理，阐述了钢结构工程防腐涂料及配套体系，并简述了涂装工艺要点。
On the basis of electrochemistry principle, this paper introduced the corrosion protective coating system for steel structures and indicated the critical points during application.
针对所制试样，从浸蚀、电化学腐蚀和高温氧化三个方面进行耐蚀性能及其机理的研究。
Corrosion resistance and mechanisms of these alloys were researched through erosion, electrochemical corrosion and high temperature oxidation.
采用阳极极化和电化学阻抗谱（EIS）技术研究了AZ31镁合金的电化学腐蚀行为。
The electrochemical behavior of AZ31 Mg alloy was investigated by measuring anodic polarization curves and electrochemical impedance spectroscopy(EIS).
通过电化学分析和磨损实验，比较了不同工艺条件下陶瓷层的耐电化学腐蚀及耐磨性能。
The electrochemical corrosion resistance and abrasion resistance are compared by electrochemical analysis and fretting test.
通过电化学分析和磨损实验，比较了不同工艺条件下陶瓷层的耐电化学腐蚀及耐磨性能。
The electrochemical corrosion resistance and abrasion resistance are compared by electrochemical analysis and fretting test.
应用推荐