介绍了国家标准关于漆膜厚度的测试方法。
The national standards for film thickness testing methods are introduced.
使用的涂装电压要能保证漆膜厚度达1.0mil (25um)。
使用高压无气喷枪喷涂导致上述部位虚喷，漆膜厚度没有达到工艺要求。
Virtual spraying with high-pressure airless spraying gun at the above sites leads to thinner coating! that can not meet the process requirements.
可按照使用目的或区域修改漆膜厚度，但这会相应改变涂布率、干燥时间和重涂间隔。
May be specified in another film thickness than indicated depending on purpose of use and area. This will alter spreading rate, drying time and recoat interval.
研究了酸中和后树脂水分散性的影响因素和电泳工艺参数对电泳漆膜厚度和外观的影响；
The factors that influenced the dispersibility of the modified acrylic resin in water, and the film thickness of the electrodeposition were studied.
介绍了国家标准关于漆膜厚度的测试方法。简要介绍了干膜和湿膜的测定方法和使用范围。
The national standards for film thickness testing methods are introduced. A brief introduction is made to the testing methods of dry and wet film thickness, and service range thereof.
通过对比几种工艺参数对膜厚的影响及实施的可行性分析，最终得出改变漆膜厚度的最佳方案。
By comparison of the influence of some technical parameters on the thickness, along with the executive feasibility analysis, the optimum project for changing the film thickness was obtained.
讨论了机器人喷涂涂料时，漆膜厚度控制的意义、影响漆膜厚度的因素以及相应参数的调整方法。
The significance of film thickness control during spraying by robot, influence factors thereof and adjustment of relevant parameters are discussed.
且由于表面是这么的不平滑，所测量到的这21块钢板上干后的漆膜厚度才会显现出这么大的幅度。
And because the surface is so uneven, the dry film thickness on the 21 panels measured exhibited this wide range.
阐述了聚氨酯漆施工工艺：喷涂前表面预处理方法、喷涂前表面检查的内容、漆膜厚度、干燥方法。
The polyurethane painting technologies, such as the surface pretreatment on steel parts before spraying coating, surface checking contents, thickness of painting film, drying method, are expounded.
本文研制了炭黑-漆酚醛树脂导电涂料。讨论了导电填料炭黑的含量、研磨时间以及漆膜的厚度对涂料导电性能的影响。
Carbon black -urushiol formaldehyde resin conductive paint has been prepared in this paper. Effects of carbon black content, grinding time and the thickness of paint were investigated.
本文研制了炭黑-漆酚醛树脂导电涂料。讨论了导电填料炭黑的含量、研磨时间以及漆膜的厚度对涂料导电性能的影响。
Carbon black -urushiol formaldehyde resin conductive paint has been prepared in this paper. Effects of carbon black content, grinding time and the thickness of paint were investigated.
应用推荐