在碳刷与滑环之间出现大量火花。
Plenty of sparks appeared between the carbon brushes and the slip rings.
其泵内装有滑环式组合密封。
用卡尺，测量滑环的直径。
检查励磁系统，检查滑环和整流子的运行状态。
2 check the excitation system, inspect the running state of the slip ring and the commutator.
配置封闭式输电滑环，电缆线不缠绕，导电良好。
Equipped with a closed transmission slip ring, cable is not wrapped, good electrical conductivity.
电刷和滑环部分应作好绝缘工作，以免出现危险。
Suggest to insulate from this part of the electronics brush and the rolling rings in order to avoid the danger.
把滑环装在排气锥体中的两个主要问题是温度和传动。
The two chief problems in installing the sliprings in the bullet seemed to be the temperature problem and the drive problem.
转台上的数据一般采用机电滑环传输至转台之外的主控计算机。
The data on the turntable were always transmitted by electromechanical slip-rings to the main control computer.
把导线排好并做必要的连接，防止导线妨碍电气滑环的自由旋转。
Route the wiring and make the neccessary connections. Do not allow the wiring to restrict free rotation of the slip ring.
本文提出了一种基于DSP和光纤滑环的光纤数据传输系统的设计方案。
A kind of optical fiber data transmission system based on DSP and optical fiber slip-rings was proposed in this paper.
电极通过导线连接滑环，滑环与转轴同步旋转，滑环连接数据采集系统。
The electrode is connected with a slip ring through a conducting wire. The slip ring and a rotating shaft rotate synchronously. The slip ring is connected with a data acquisition system.
电极通过导线连接滑环，滑环与转轴同步旋转，滑环连接数据采集系统。
The electrode is connected with a slip ring through a conducting wire. The slip ring and a rotating shaft rotate synchronously and the slip ring is connected with a data acquisition system.
若是滑环式电动机(绕线转子)，去除电刷，和铜环连在一起使滑环短路。
Remove brushes and short the ring together with a copper link in case of a slip ring motor (wound rotor).
采用新型的滑环组，保证足够的接触面积和压紧强度，更好的传递电流。
The explosion-proof cable drum adopts a novel slip ring group, guarantees enough contact area and compression strength, and better transfers current.
其基本原理是将交流电机的滑环输出功率通过整流电桥和有源逆变器送回交流电网。
The basic principle of the system lies in feeding back the output power at the motor slip rings of an AC motor into the mains through a bridge rectifier and an inverter.
选用滑环结构以实现无限旋转的目的，从而避免了信号线在测量臂内部绞断的问题。
Slip rings are utilized to realize the purpose of unlimited rotation, so as to avoid the signal line within the measuring arm to break down.
天平设计要保证质量分布均匀，采用特制滑环引出电信号，并且天平后端用支架支撑以减小振动。
In the balance design, even distributed mass is required, special slip ring is taken to get electric signal and fixed mount is used at balance rear end to eliminate vibration.
多路信号经滑环传送效果关系到各种检测设备的性能，是无损检测(NDT)行业着力解决的课题。
The effect of transfering multichannel signals in sliding loops relates to various tester's ability, and it is a challenging task for the NDT profession.
利用滑环装置测量了喷油单螺杆压缩机转子螺槽的表面温度，给出了各种不同工况下表面温度的数据。
The surface temperatures of grooves of an oil-flooded single screw compressor are measured with a slide-ring, and the surface temperatures on different working conditions arc given.
探讨螺旋CT的滑环接触性能变差后常见的扫描中断故障，并结合实践总结出了滑环维护保养的一般方法。
This paper discussed one type scan-aborted malfunction which is caused by carbon-brushes' contact-capability abated in the Helical CT, and summarized carbon-brushes general maintenance method.
先拆下电动机的护罩、滑环、碳刷、刷盒、刷盒支架及短路环装置(有的电机无短路环装置)等全部零件。
Removing all parts of cover, rings, carbon brush, brush box, brush box shell and short circuit ring equipment (some motor have no short circuit ring equipment).
本文叙述了精矿库抓斗吊车绕线式电机滑环烧损原因，提出了预防措施和建议，介绍了滑环修复标准和方法。
This paper describes the reason for burnt sliding ring of coiling motor used for clamshell crane, puts forward preventative measures and Suggestions and introduces repairing standard and method.
介绍了灯泡贯流式机组滑环碳刷系统的磨损情况，分析了滑环碳刷磨损严重的危害和滑环碳刷系统磨损的原因。
Analysis of abrasion of the slip-ring carbon and brush system for bulb hydro-generating units, its great danger and the cause of this phenomenon are presented.
通过对发电机滑环的处理及对转子一点接地保护程序的修改，有效地避免了发电机转子一点接地保护动作的再次发生。
Via slip ring disposal and modifying program of rotor one point ground protection, rotor one point ground protection operation again is effectively avoided.
利用电阻应变片、动态压力传感器、滑环式引电器和磁带记录仪等，录取叶片振动应变和动叶出口压力信号，然后回放磁带，做信号处理。
Using resistance strain gage, dynamic pressure sensor, slip ring and tape recorder, the blade vibration strain and exit pressure signals of rotor blades are recorded and then processed.
利用电阻应变片、动态压力传感器、滑环式引电器和磁带记录仪等，录取叶片振动应变和动叶出口压力信号，然后回放磁带，做信号处理。
Using resistance strain gage, dynamic pressure sensor, slip ring and tape recorder, the blade vibration strain and exit pressure signals of rotor blades are recorded and then processed.
应用推荐