粉状或颗粒状湿物料的干燥。
从而使湿物料达到了干燥的目的。
In this way the dry purpose of damp raw material is reached.
所谓粉碎湿物料方面就不用在头疼了。
The so-called crushing wet material aspects need not in have a headache.
龙开口将继续粘湿物料或流动的自由。
Long openings will keep sticky or wet material flowing freely.
湿物料吸热后蒸发的水汽,通过真空泵经真空排气管被抽走。
The vaporized steam can be pumped out through vacuum exhaust pipe when the damp raw material absorbed heat.
置换干燥是利用某种置换剂来置换湿物料中水分的一种非热力干燥方法。
One of the nonthermal methods of drying and dewatering is displacement drying where solvent is used to "displace" liquid moisture from the wet material.
在生产中,因其湿物料物化性质较特殊,含水量大,致使其造粒干燥很困难。
In production, the special physical and chemical property of the wet material and high water content make the prilling and drying very difficult.
湿物料在其中被过热蒸汽加热脱水后排出干燥系统,而来自上一级干燥的过热蒸汽则冷凝为冷凝水后排出干燥系统。
Wet materials in them was overheating steam heating dehydration back out dry system, and from higher level dry superheated steam is condensed water condensation for rear out drying system.
将湿物料加入干燥机后,在管道内均布的抄板翻动下,物料在干燥机内均匀分散与热空气充分接触,加快入干燥传热、传质。
After entering the dryer, wet materials are turned over by the spread shoveling plates in the dryer pipe, and then meet the hot air completely to quicken the drying mass transfer.
对湿物料进行的真空微波干燥、真空干燥和微波干燥试验表明真空微波干燥升温速度最快,干燥效率高,物料的干燥质量好。
The acquired results show that the vacuum drying technique with microwave is better than other methods in terms of temperature rise rate, drying effect and drying quality.
半湿物料粘壁主要与喷雾干燥塔结构、雾化器结构、安装、操作以及热风在塔内的运动状态有关。物料熔点低于干燥温度时容易产生热熔性粘壁。
The wall sticking of half wet material is concerned to the structure, fixing and operation of spray drying tower and sprayer, the motion of hot air in tower.
该方案还可用于其它物料加湿以抑制粉尘散发。
This plan cart be also used to moistening other materials to control diffussion of their dust.
双级粉碎机在下雨天也可以照常生产,对于干料湿料没有任何要求,粉碎含水率100%的物料也不会发生堵塞。
Double level in the rainy day can also as usual mill production, and for dry material wet material without any requirements, moisture content 100% of the material crushing also won't happen jam.
箱式烘干机采用三层上下往返式行进,使物料在有限的空间内充分吸热排湿达到烘干效果。
Two, box dryer with three layers from top to bottom travel, so that the material in a limited space to fully absorb heat and humidity to achieve drying effect.
稍有湿的物料,如砂、煤、化工原料等。
Slightly wet materials, such as sand, coal, chemical raw materials, etc.
适用于粉状、颗粒状物料的干燥、冷却、增湿等作业(或同时进行)。
It is widely used for operation of drying, cooling and damp increasing (or carry out at the same time) for power or granule material.
本文基于微波测湿理论,对粉粒物料水分的微波测量方法进行了探讨。
This paper discusses the microwave measurement to measure the moisture of the powder.
环锤式破碎机经高速转动的锤体与物料碰撞物料,它具有结构简单,破碎比大,生产效率高等特点,可作干、湿两种形式破碎。
Ring hammer crusher by high-speed rotating hammer and material crushing material, It is simple in structure, big crushing ratio, high production efficiency. Used for dry, wet two forms.
型混合机广泛用于混合粉状或湿性物料,使不同比例主辅料混合均匀。
Model CH mixer is wide suitable for mixing power or damp raw material and make primary and auxiliary raw material can be mixed uniformly.
简要讨论了湿冶离子交换制取APT工艺中钨回收率的问题,从物料平衡的角度理论计算钨回收率正常情况下应为98。
The recovery rate of tungsten in production of APT by ion-exchange technique of hydrometallurgy is discussed, theoretical calculation of recovery rate is 98.
湿解过的物料很少损失有机质,可以直接制作符合国家标准的肥料。
With little loss of organic substances, wet-degraded material can be directly prepared into fertilizer in accordance with national standards.
根据物料及排矿方式,可选择干式球磨机和湿式格子型球磨机。
Moreover, according to different materials and discharging methods, there are dry ball mills and wet ball mills for choice.
本实用新型具有如下效果:该排湿装置具有排湿速度快、物料快速干燥、进风量可以调节,且操作简单等功能。
The utility model has the effect that the humidity-discharging device has functions of fast humidity-discharging speed, quick material drying speed, adjustable supply air rate and simple operation.
医药、食品、饲料、化工等领域湿颗粒和粉状物料干燥。
Pharmaceutical, foodstuff, feed, chemical industries and so on fields.
医药、食品、饲料、化工等领域湿颗粒和粉状物料干燥。
Pharmaceutical, foodstuff, feed, chemical industries and so on fields.
应用推荐