理论分析和实验测量都已表明,渐变内插管结构具有较好的消声效果和较小的流阻损失。
It shows that the gradual change structure can offer better sound reduction and smaller flow loss.
具有最低的流阻(实际上为零)。
对多纵向涡对管内湍流换热和流阻特性进行了数值分析。
The characteristic of turbulent heat transfer and flow resistance with multi-longitudinal vortexes in tube is numerically analyzed.
现有扶正器有易疲劳损伤、对接不严、流阻损耗的缺点。
The current centralizer has such defects as being apt to tire and wear off, worse seal and the wasting of fluid resistance.
在第三流动区,可以近似用牛顿流体流阻方程计算流阻。
The loss in the third fluid area can be calculated approximately by the newtonian fluid pressure loss equation.
结果表明,纵助管束具有低流阻特性和较强的传热强化作用。
The heat tranfer and pressure drop performance of cross flow longitudinally finned tube banks heat exchanger are reported.
本文理论和实验研究了通过改变回热器流阻进行直流抑制的可行性。
The possibility of utilizing regenerator flow resistance to suppress DC flow is theoretically and experimentally investigated.
孔隙率,面密度,厚度,流阻,结构因数因素综合影响其吸声系数。
Porosity, surface density, thickness, flow resistance, structure factor and other factors affect the sound absorption coefficient.
阐述了在微小流量节流器中用多孔金属材料作为流阻器所产生的效果。
The results of using porous metal for micro-flow throttle are presented.
单元模块采用重力沉降、惯性阻挡、绕流阻留、离心力等多种除尘机理。
The unit modules adopt a plurality of dedusting mechanisms, such as gravity settling, inertia blocking, flow around retaining, centrifugal force, etc.
在常压条件下,对水平钛波槽管管外凝结换热及流阻特性进行了实验研究。
Experimental investigation of heat transfer and friction characteristics was conducted on the outside of a horizontal titanium circular-grooved tube under atmospheric pressure.
气流流经散热细管的流阻较小,因此可以较好的满足通信设备的散热要求。
The flow resistance of airflow flowing through the heat dissipation thin tubes is low so as to well meet the heat dissipation requirement of the communication equipment.
结果表明,多纵向涡可明显强化管内湍流换热,其流阻增加与换热增强相当。
The results show that the multi-longitudinal vortexes could enhance the turbulent heat transfer in tube markedly and the flow resistance increase is similar to heat transfer enhancement.
应用二维场量分布进一步得到了平均磁流阻率随电流密度和温度的变化特性。
The average flux-flow resistivity depending on the average current density and temperature is also calculated with above distributions.
蝶阀在开启时蝶板与流体流向平行,流阻小,流通截面大,阀芯不易被冲刷;
When opening the valve, the valve disc is parallel with the flow direction. The flow resistance is little, the flow section is large and the core will not be eroded.
通过减小腔内回流比例、增大正反方向流阻差,提高泵液效率与输出泵压、减小输出脉动。
By reducing the reverse flow in chamber and by increasing resistance difference of back-and-forth flow, higher efficiency, higher pressure and less output fluctuation could be expected.
此外还从传热与流阻性能、传热效率、紧凑性和经济性等方面对板式换热器的整体性能进行了评价。
The bulk characteristics of the PHEw ere evaluated from heat transfer and pressure drop characteristics, heat transfer efficiency, compactness and economic characters etc.
滋墨:印纹上,油墨向外蔓延的情况。引致滋墨的原因很多;例如压印压力,油墨流阻度,纸张吸收性等。
Spreading: ink crept on printed areas. there are many factors causing ink to spread; such as printing pressure ink viscosity paper absorbency etc.
用添加稳态故障的方法分析了燃气发生器和燃烧室氧化剂管路流阻系数,以及氧化剂温度对发动机参数的影响。
The simulation by adding stable state fault was used to study the effect of flow resistance coefficient of oxidant pipe in gas generator and chamber and oxidant temperature on the engine parameters.
球阀在完全开启时,流阻很小,几乎等于零,因此等径球阀广泛应用于石油天然气管线中,因为容易清扫管线。
Ball valve fully open, the flow resistance is very small, almost zero, so the ball valve diameter is widely used in petroleum and natural gas pipelines because the pipeline cleaning easy.
结果表明:通道出口段存在气膜出流与无气膜出流情况相比出口段有效压力分布发生变化,并且使整个通道的流阻下降。
Experimental results showed that the effective pressure distribution of the exit section was different and the flow friction decreased due to the influence of film bleeding.
电子负载可以设置为恒流﹐恒阻和恒压模式。
Electronic load can be set for constant current, constant resistance and constant voltage operation.
当热阻较大一侧有旋流存在时,离心浮力对换热器传热性能的影响更为明显。
Furthermore, the influence of centrifugal buoyancy on the performance of heat transfer was more distinct in the case of swirling flow existing in the side of larger thermal resistance.
在此基础上,进一步分析了波浪入射波高、入射角度、底摩阻及驼峰高度对裂流的影响,得出了一些有用的结论。
Based on this model, we analyze the effects of the change of wave height, wave's incident Angle, bottom friction coefficient and topography on rip current, and some useful conclusions are reached.
本文提出了微圆管内环状流凝结换热的分析模型,考虑了重力、汽液界面剪切力、表面张力以及界面凝结热阻的作用。
Considering gravity, interfacial shear stress, surface tension and interfacial thermal resistance, the analysis model for annular flow condensation heat transfer in microtube was presented.
使用解析形状函数法和参数化翼型表示方法,将求解绕翼型流场的N S方程解与优化方法相结合,可设计出新的高升阻比翼型。
The combination of a N-S equation flow solver with a nonlinear optimization method is used to design a new airfoil with high ratio of lift over drag.
当扩展时,阻流门阻止风扇排气,迫使空气反向通过级联段。
When extended, the blocker doors block the fan exhaust, forcing air in the reverse direction through the cascade segments.
将压井阀和阻流阀注满海水。
即使小电流导体和附件电压源之间的高阻通路也会产生明显的漏流。
Even high resistance paths between low current conductors and nearby voltage sources can generate significant leakage currents.
在计算排出口压力计算过程中,考虑了由于抽油杆柱旋转引起杆管环空气液两相流摩阻的影响。
To calculate discharge port pressure, this article considers the influence on frictional pressure drop in the gas and liquid two-phase flow between rod and tubing owing to rotation of rods.
应用推荐