计算并绘出了非稳区域边界，分析了非稳振荡波形变化规律及其模结构。
The regularity of the change of the unstable oscillation wave form and the structure of the power spectrum were analysed.
介绍离合器从动盘总成中的一种典型波形片零件的冲压工艺及弯曲成形模设计。
The stamping technique and design of bending former for a typical waveform piece in clutch driven plate assembly were introduced.
该电源采用数/模混合控制及重复控制方法，数字部分实现高精度的波形发生器和电压有效值控制；
The power supply adopts D/A mixed control and repetitive control. The digital part realizes the high precise waveform generator and the control based on voltage virtual value.
阐述了波形弹簧成形模曲面的确定及其数控加工程序的编制方法、加工工艺过程。
The paper expounds the method of design about wave spring curved surface, the processing NC program and its technological processing course.
从理论和实验上研究了不同焦距下泵浦能量以及透镜与光纤间距对多模光纤中的SBS能量反射率和脉冲波形的影响。
The influences of pump energy, focal length and distance between fiber and lens on SBS reflectivity and waveform in multimode fiber are investigated theoretically and experimentally.
微带线泄漏一般分为表面波形式和空间波形式两类，其中微带线高次模泄漏一般以空间波的形式发生。
The leakage of microstrip line has two forms: the surface wave form and the space wave form, and the higher order modes on microstrip line mostly leak as space wave form.
该算法在现有的恒模算法(CMA)的基础上，进行了一定的改进，充分利用了CDMA系统中扩频波形信息和信号的恒模特性。
This algorithm, an improved method based on CMA (constant modulus algorithm), utilizes the information of spread codes and the performance of constant modulus in CDMA communication system.
采用滑模变结构控制策略，进行了波形控制技术研究。
The waveform control technic for inverter is studied based on the designed DSP embeded controlling system.
传统二极管箝位变换器的电压变化率和共模电压较高，且波形谐波含量较大，使得输出滤波器的设计变得复杂。
Traditional diode-clamped converters have high voltage variation rate, common-mode voltage and harmonics, which make the design of its output filter complicated.
采用焊管作为管坯 ，焊管弯曲采用专用模具热弯 ，焊接采用等离子弧焊。超塑成形采用多层模结构 ，用模具来控制波形。
Welded pipe that bended by hot bending method with a set of specific die and welded by plasma arc welding method was used as tubular blank of SPF.
采用焊管作为管坯 ，焊管弯曲采用专用模具热弯 ，焊接采用等离子弧焊。超塑成形采用多层模结构 ，用模具来控制波形。
Welded pipe that bended by hot bending method with a set of specific die and welded by plasma arc welding method was used as tubular blank of SPF.
应用推荐