然后，利用矩阵递推方法，求出多层横观各向同性地基在表面荷载作用下位移和应力的一般表达式。
With the matrices recurrence method the analytical formulas to study the displacement and stresses of transversely isotropic layers, subjected to surface loading are derived.
主塔基础采用分离式承台钻孔桩基础，两承台设横系梁连接，系梁为预应力混凝土结构。
The foundation of the pylon is composed of bored piles and separate pile caps connected with prestressed concrete tie beams.
当韧性材料被测试时，由于颈缩使横载截面面积减小，以至在受力没有增加的情况下引起应力的增加，以保证延伸继续如常进行。
When a ductile material is tested, the reduction in cross-sectional area due to waisting causes an increased stress without an increased force, to ensure that extension proceeds uniformly.
在弹性、横观各向同性条件下，计算得出了表征土壤-根系复合体应力-应变关系的本构方程。
The constitutive equations of the soil-root composite, which express the stress-strain relationship, were derived under the hypothesis of isotropy.
利用该方法对苏通大桥进行整体受力计算，得到钢箱梁板件的横桥向和顺桥向应力，分析了钢箱梁顶板应力在横桥向的不均匀性。
Mechanics behaviors of Sutong bridge were computed by this method, and longitudinal stress, transversal stress of plates of the girder and section stress distribution were discussed consequently.
本文主要讨论梁横力弯曲，忽略纵向纤维间无正应力假设的准确性。
The paper mainly discusses the shearing bending of beam and the veracity of the hypothesis that there is no direct stress between the longitudinal fibers.
对于工况参数，主要分析了横移量、轴重和轨底约束对轮轨滚动接触应力场的影响。
The effects of case parameters on the distribution of elastic-plastic stress hi railhead are analyzed including lateral displacement, gross rail load on axle and constrained conditions of rail bottom.
采取去掉横拉筋的办法改造抽油机游梁支架，可节省大量钢材，降低制造成本。对改造后的游梁支架进行了动态应力测试、位移测试和稳定性计算。
Through modification of the framework of a beam pumping unit by removing the cross tension link, a great quantity of steel can be saved and the manufacturing cost can be reduced.
利用三维弹塑性有限元软件L S- DY NA对一种典型偏心轴类零件楔横轧成形进行了数值模拟，分析了其成形过程、应力应变场分布及工艺特点。
The cross wedge rolling deformation process of shaft parts with eccentric section was simulated with three-dimension finite element soft LS-DYNA by using elastic-plastic finite element method.
利用三维弹塑性有限元软件L S- DY NA对一种典型偏心轴类零件楔横轧成形进行了数值模拟，分析了其成形过程、应力应变场分布及工艺特点。
The cross wedge rolling deformation process of shaft parts with eccentric section was simulated with three-dimension finite element soft LS-DYNA by using elastic-plastic finite element method.
应用推荐