提出了汽轮机热力性能的概率设计法。
This paper presents a probabilistic design method for thermal performance of steam turbines.
本文提供了机床夹具一面两销定位的概率设计法，给出了计算示例，并进行了计算机模拟。
This paper offers the probabilistic design for the jig of machine tools locating with one plane and two pins and presents calculating examples and makes computerized simulation.
连续配筋混凝土路面(CRCP)在我国有了一定的应用，其设计还未完全采用基于可靠性理论的概率设计法。
Since Continuously Reinforced Concrete Pavement (CRCP) has got some application in China, probabilistic design based on reliability theory has not been used completely in the design procedure.
本文是探讨近似概率法在钢筋砼无梁板截面设计中的应用。
This paper introduces approximate probability method in designing the section of reinforced concrete non-beam plate.
因此，研究雨水管网的可靠性，采取基于可靠性理论的概率极限状态设计法来设计雨水管网有着重要的实际意义。
So studying reliability of rainwater pipe network and adopting probability limit state design method based on reliability theory to design rainwater pipe network have important actual meanings.
运用体积开裂概率分析了大体积混凝土结构的抗裂可靠性，并结合有限元法对控制裂缝设计与施工进行了研究。
The paper analyses the anti cracking reliability in massive concrete structure with the concept of overall crack probability, presenting the cracking control design and construction combined with FEM.
提出了砂井地基固结概率设计的一般步骤，并用算例说明了该法在实际工程中的应用。
A probability design procedure for consolidation of sand-drained ground is established and its practical application is illustrated by example.
用循环计数法求出载荷及应力幅频率分布，用概率密度函数拟合，为疲劳设计提供可靠性高的数据资。
The loads and the distribution of stress amplitude frequency are obtained by cycle count and reliable data for fatigue design are provided by probability density function fit.
为了逼近存在最大响应值的区域，用最速上升法确定95%概率水平上显著因素的设计中心点。
Subsequently the steepest ascent method is applied to obtain the design center point of the significant factors above the 95% probability level.
概率结构优化设计(PSDO)中概率约束的评定可以采用最近提出的、被认为更高效、稳定的功能度量法(PMA)。
The evaluation of probabilistic constraints in probabilistic Structural Design Optimization (PSDO) can be carried out using the recently proposed performance measure approach (PMA).
并对传统方法与联合概率法，以及采用不同的取样方法分别进行了比较，为平台设计提出了合理建议。
Through the comparison with traditional design methods, the present approach leads to some Suggestions about determining the design standard for platform.
初始缺陷和强度参数为设计变量，采用一阶矩法计算单元层的失效概率。
The initial imperfection and the strength parameters are considered as random variables. Ply-level failure probability is evaluated by the first order reliability method.
当前的工程结构设计，在国内的结构设计规范中，多已采用以概率理论为基础的极限状态设计法。
Most of recent domestic design codes of engineering structures have adopted the Probability-Based Limit State design Method.
引入概率的极限状态设计概念，研究JC法推求梯级水库设计洪水的理论。
The probabilistic design conception on limit state was introduced, and the theory using the JC method to compute the cascade reservoir's design flood was studied.
现行建筑内部给水、排水设计秒流量计算方法有平方根法、经验法和概率法等。
Currently the methods of design flow rate for domestic drainage which are popularly used in the world include square root method, experience method and probability method.
介绍了概率极限状态设计法在确定地基承载力中的应用，可供工程实践之参考。
The application of probabilistic limit state method in confirming the bearing capacity of foundation soil is introduced. It can be used as reference in engineering application.
为了确定适当的乘法规范化系数，作者给出了概率分析法和等效查表长度两种设计方法。
In order to choose an appropriate multiplication normalization factor, two methods based on a probability analysis and the equivalent look-up table size, respectively, are proposed.
为了确定适当的乘法规范化系数，作者给出了概率分析法和等效查表长度两种设计方法。
In order to choose an appropriate multiplication normalization factor, two methods based on a probability analysis and the equivalent look-up table size, respectively, are proposed.
应用推荐