本主题表示要拥有大量森林覆盖和立木材积的总愿望,包括森林外树木,以支持林业的社会、经济和环境方面。
The theme expresses an overall desire to have significant forest cover and stocking, including trees outside forests, to support the social, economic and environmental dimensions of forestry.
在林业生产实践中,用灰色系统模型预测人工林材积生长率有其适用价值。
It is worth while to apply the gray system model to predict the forest growth in practice.
桐粮间作能在一定程度上提高农作物品质和产量,且能增加泡桐材积,提高经济效益。
The intercropping system can not only increase quality and output yield of crops, but also increase the paulownia volume and economical benefit.
据此,在利用材积密度法估计树干干重时,相同树种不同个体可以采用统一的平均密度值。
Same average density can be used to estimate stem dry weight of the same species of trees.
立木材积表是森林经营中必不可少的工具,材积表的精度直接影响森林调查结果的可靠性。
Standing stock table is a necessary tool for forestry management, whose precision directly affects the reliability of the forest survey.
本文提出了一致性分段式削度方程和一致性材积比方程。
In this paper a compatible segmented taper equation and a compatible volume ratio equation are developed.
胸径、材积、冠幅、新梢生长量随造林密度减小显著增大。
The DBH, volume, crown breadth and the growth of shoots increase obviously as the density decreases.
原木材积的检测在林业研究及造纸工程等领域是十分重要的。
Log volume inspection is very important in forestry research and paper making engineering.
结合该系统的特点,对改进我国材积表体系提出了一些建议。
System, Suggestions are also given to improve the Volume Table System, presently used in China.
另一方面,排水法可用来精确求得树木任一部分的立方材积。
The displacement method, on the other hand, can be used to obtain accurately the cubic volume of any part of the tree .
等长且堆放成捆的原木材积由人工检尺测得,会产生很大误差。
There is large error in manual measuring equal length and heaping log volume.
杉木在树高、胸径和材积等生长性状间有较高的表型和遗传相关性。
The relatively high phenotype and genetic correlation of Cunninghamia lanceolata exist between growth characters of height, dbh and volume, etc.
模型检验进一步证明该模型系统提供了最好的直径和材积预测精度。
Model validation further confirms that this model system provides the best precision of diameter and volume prediction.
在杉木子代测定中,观测了各年到16年(或7年)的树高,胸径和材积生长。
Stem height, diameter and volume growth were measured at various ages up to that of 16 (or 7) in a Chinese Fir progeny test.
松针红蜡蚧虫口密度与针叶变黑呈正相关,受害木的材积生长率受到较大影响。
The population density shows a positive correlation to the blackening degree of the needle.
给出了按不同的区分方法和求积算法计算树干材积的方法、程序及相应的材积误差率。
It shows the methods to calculate the trunk volume by different sectional ways and product calculation methods and programs, as well as relevant error ratios of timber volume.
结果表明,无性系间树高、胸径、材积、木材基本密度和管胞长度存在显著至极显著差异。
The results indicated that the five traits like height, diameter at breast height, volume, wood basic density and tracheid length showed at least significant genetic variation among clones.
建立了病害发生的短期测报模型和材积损失率估测模型,确定了病害的防治指标和经济阈值。
Short term forecast model of disease development and wood loss rate are built. Control guideline and economic threshold value are decided.
史密斯桉种源试验结果表明:树高、胸径、材积种源间变异相对较小,而种源内个体间的变异较为丰富。
The provenance experiment on Eucalyptus smithii shows that height, DBH, volume have little variation in provenance, and great variation in individuals.
论述贵州现用一元立木材积表存在的问题和误差来源,对原材积式与新材积式进行误差对比及适用性检验。
This paper analyzed errors and their origins in Timber Volume Table (TVT) of Guizhou Province and deemed it imperative to revise TVT.
在采伐作业设计和伐后验收的蓄积计算上应采用相同的计算方法或编制区域性根径一元材积表,以减少误差。
It should use the same volume calculation method or make one way volume table for felling design and acceptance after felling to reduce errors.
凉水溪流河岸带森林立木材积、林分蓄积及溪流倒木数量、平均倒木体积和总倒木蓄积量均高于帽儿山溪流。
The standing tree volume, stand stocking of riparian forest stand, number, average volume and total stock of in-stream LWD at streams in Liangshui were greater than that of Maoershan.
酶带频率变异与树高、胸径、材积生长相关性很小,只有B _(45)酶带与生长相关达到或近于显著水平。
The correlation between frequency variations of enzyme bands and tree height, DBH and volume was very small. Only B45 band came up to or closed significant level.
通过对渭北黄土高原刺槐人工林最大林木的树干解析和年轮分析描述了林分最大两株林木的树高、直径和材积生长过程。
Growth process of height, diameter and volume of the largest two stems of some sampled black locust stands on Weibei-loess plateau were described by analyzing stem disks and growth rings.
随着密度的增加,林分达到数量成熟期的年限变短,若以数量成熟期为采伐年限,则单位面积年均材积产量仍以高密度林分为最大。
Higher density stands reach quatitive maturity earlier than lower density stands, the annual stem volume produced by unit land area of higher density stand is larger than that of lower density stands.
影响油锯择伐作业中保留木损伤率的因素很多,经过分析可知采伐强度、林分密度和采伐木单株材积是影响保留木损伤率的主要因素。
Selective cutting intensity, stand density and felling tree volume per stem were considered as the major influencing factors by analyzing related researches at home and abroad.
通过子代测定选出的优良家系,其有性后代在树高、胸径和材积早期生长的遗传增益分别为8.24%,14.33%和24.16%。
The genetic gains of superior families selected by progeny tests on early tree height, diameter breast-high and volume growth were 8.24%, 14.33% and 24.16% respectively.
根据胸径、树高和材积进行优良家系的初步选择,选择前50个优良家系所获得的遗传增益分别为17.8%、18.6%和18.7%。
The genetic gains of 17.8%, 18.6% and 18.7% would be got when 50 plus families were primarily selected based on DBH, height and volume respectively.
在树高、胸径和材积3个生长指标上,美国黄松具有很好的相关性,相关系数均在0.9以上;而油松的树高与胸径相关系数仅为0.583。
Compared to P. tabulaeformis, the height and diameter growth and volume of P. ponderosa have good relativity, and correlation value was more than 0.9, but P. tabulaeformis was only(0.583).
与实际树高相比,重建树高中最大误差是4.4%,最小误差为0.7%,在此基础上计算的材积最大、最小误差分别是4.7%和2.1%。
Compared the evaluated height with the true tree height, the errors were within 0.7% to 4.4%, and consequently the errors of volume between 2.1% and 4.7%.
应用推荐