测定了处理后驼毛的减量率、直径减小率、初始模量、断裂强力和断裂延伸度。
The initial module, strength at break, breaking extension after treatment were measured and compared with that of the control sample.
研究结果表明，复合材料拉伸弹性模量随增强体含量增加而升高，断裂延伸率下降。
It is shown that the elastic modulus increases with volume fraction of ceramic particles, though the fracture strain decreases.
不同电位下，SRB存在时试样的断裂延伸率均低于海泥中不含SRB时的断裂延伸率。
The elongation rates of the specimens in marine mud with SRB under different potentials are lower than those in marine mud without SRB.
本文讨论了常温固化不饱和聚酯树脂浇涛体的拉伸强度、拉伸模量、断裂延伸率与固化度之间的关系。
In this paper, the relation of tensile strength, tensile modulus and breaking elongation of unsaturated polyester casting matrix cured at room temperature to curing degree was discussed.
研究结果表明：经过大变形后，由于纯铜的晶粒得以细化，抗拉强度、屈服强度、硬度和断裂延伸率都显著增加。
The results show the tensile strength, yield strength, hardness and elongation increased obviously due to the decreasing of the grain size of pure Cu after severe plastic deformation.
具有较高的热变形温度、断裂延伸率和冲击韧性，有效防止了制品在生产和使用中的开裂，同时具有固化快的特点。
A higher distortion temperature, elongation and fracture toughness, effectively preventing the production and use of products in the cracking, a fast curing the characteristics.
自周四开始的这轮地震集中于从九州岛西南部延伸至东北部的一条地质断裂带，这条线将该岛一分为二。
The earthquakes since Thursday have been concentrated along a cluster of fault lines that bisect the island of Kyushu from southwest to northeast.
断裂面从轴承部位外部开始延伸到整个截面。典型的是从圆弧部开始，常常会由于疲劳而产生的裂纹的扩展后引起的。
Fracture lines start from the outside and spread over the whole cross section, particularly starting in the fillet area and very often after a fatigue crack propagation.
试验结果表明，铝内衬的极限断裂应变仅为材料极限延伸率的25%。
The test results shows that AL-liner fracture strain is only 25 % of material ultimate strain.
介绍了采用满粘法施工的SBS防水卷材屋面系统避免零延伸断裂的防水施工技术。
The article introduces the technique of fully-adhered SBS waterproofing membrane roofing system, which can prevent zero elongation rupture.
作者认为该矿受NW向断裂构造控制，并有向SE倾伏延伸之趋势。
The authors considered that this orebody is controlled by NW faults, with a dip of SE.
然而廷贾断裂的范围其北端的位置只划分在南沙海槽的西南端，而南侧延伸到加里曼丹岛上。
Thirdly, the northern scope of the Ting Jia fracture is only division in the southwest of the Nansha trough. But the south of it extends to the south side of the island of Kalimantan.
介绍了涂膜拉伸强度、断裂时的延伸率，防碳化效应特性试验以及弹性外墙乳胶涂料施工应用技术。
Tests on film tension strength, elongation rate at breaking, anti carbonation effect etc. and applied technique of elastomeric latex coating for exterior wall are described.
分别应用断裂力学中的最大拉应力理论和应变能密度因子理论分析了重复压裂中水力裂缝的初始扩展和延伸方向。
By maximum tension theory and maximum strain energy density theory in fracture mechanics, created and propagation direction of new artificial fracture are analysized.
选择适当的温度和拉伸比进行热定形，可提高PTT织物的断裂强力和弹性回复率，但其延伸性变差。
The breaking strength and resilient-elasticity recovery of PTT fabric can be increased under suitable temperature and drawing ratio during heat setting, but its dilatability took worse.
合金在高应变速率的变形中通过动态再结晶可获得更细的晶粒尺寸，其断裂时总延伸率在135%左右。
They also show that a finer grain size can be obtained by dynamic recrystallization during superplastic deformation at a high strain rate, but the total elongation to failure is limited in about 135%.
这个过程工业生产的高品质纱线具有低，断裂伸长率和低延伸率的参考，或低热量，低收缩率的参考伸长。
The process produces yarns of high industrial quality having a low break elongation and low reference elongation, or a low heat shrinkage and low reference elongation.
该年龄与东昆中断裂附近的清水泉蛇绿岩的时代可以很好地对应起来，这为清水泉蛇绿岩带向西的延伸方向及东昆仑地区东段早古生代的构造演化提供了新的年代学证据。
This result thus provides new chronological evidence for the western extension of the Qingshuiquan ophiolite zone and the evolution of the eastern part of the east Kunlun region in Early Paleozoic.
微量元素的分布于断裂的产状有较密切的关系，高值区同断裂的向上延伸方向对应。
The distribution of trace elements in form in the fracture of a closer relationship, high value area of extended upward direction correspond to fracture5.
经C路径的二次ECAE加工后试样为各向同性材料，其缺口冲击强度较PP有所提高，拉伸强度下降，断裂伸长率提高，表现出很好的延伸性。
The specimen by route C ECAE processing was isotropic and its impact strength increased, tensile strength decreased, elongation at break improved and show…
经C路径的二次ECAE加工后试样为各向同性材料，其缺口冲击强度较PP有所提高，拉伸强度下降，断裂伸长率提高，表现出很好的延伸性。
The specimen by route C ECAE processing was isotropic and its impact strength increased, tensile strength decreased, elongation at break improved and show…
应用推荐